ENGLISH | 18 |
Problem
•Continuous flash of the light of the
running pro- gramme.
•Intermittent audi- ble signal.
•3 flashes of the
end indicator light.
Malfunction:
The
Malfunction:
The programme does not start.
Possible cause | Solution |
Close the water tap and Contact your local After Sales Service.
The appliance door is not closed. |
| Close the door. |
|
Mains plug is not connected in. |
| Put in the mains. |
|
|
|
|
|
The fuse has blown out in the |
| Replace the fuse. |
|
household fuse box. |
|
|
|
|
|
|
|
After the check, switch on the appliance. The programme continues from the point of interrup- tion. If the malfunction shows again, contact your After Sales Service.
When the cleaning results are not satisfactory:
Problem |
| Possible cause |
The dishes are |
| The selected washing programme is |
not clean |
| not applicable for the type of load |
|
| and soil. |
|
|
|
|
| The baskets are loaded incorrectly so |
|
| that water cannot reach all surfaces. |
|
|
|
|
| Spray arms do not turn freely because |
|
| of incorrect arrangement of the load. |
|
|
|
|
| The filters are dirty or not correctly in- |
|
| stalled. |
|
|
|
|
| The quantity of detergent is too little |
|
| or missing. |
|
|
|
Limescales |
| The salt container is empty. |
particles on the |
|
|
| The water softener is adjusted on a | |
dishes |
| wrong level. |
|
|
|
|
| The salt container cap is not closed |
|
| correctly. |
|
|
|
The dishes are |
| No rinse aid has been used. |
wet and dull |
|
|
| The rinse aid dispenser is empty. | |
|
|
|
Solution
Set different washing programme.
Load the baskets correctly.
Make sure that the cutlery and dishes do not block the spray arms.
Make sure that the filters are clean and installed correctly.
Make sure that the quantity of deter- gent in detergent dispenser is correct.
Fill the salt container with salt.
Set the water softener.
Make sure that the salt container is closed correctly.
Set the rinse aid dosage.
Fill the rinse aid dispenser.