Hill Phoenix 05DMA manual Installation

Page 9

INSTALLATION

The O5DMA is shipped with most of the exterior panels and trim already installed. The only exterior parts that need to be installed when the case arrives are the kick- plate and the end kickplates. If the cases are equipped with contour front panels the upper kickplate retainer is also shipped loose with the case.

The kickplate, which is shipped in the case, simply slips up and behind the front panel and then down onto the “J” rail. See illustration 1 below for details. When installing the upper kickplate retainer make sure it is placed behind the front panel lip as shown in illustration 1 below.

The end kickplates, which are also shipped in the case, are attached to the baseframes directly under the ends with the screws provided. There are two, smoke grey plug buttons that are inserted into each end kickplate to cover the screw holes, see illus- tration 2 below.

FLAT FRONT PANELS

FRONT PANEL

KICKPLATE

“J” RAIL

CONTOUR FRONT PANELS

1

 

FRONT PANEL LIP

 

UPPER KICKPLATE

 

RETAINER

 

KICKPLATE

 

“J” RAIL

 

END

 

BASEFRAME

2

END KICKPLATE

SCREW

PLUG BUTTON

5

Image 9
Contents Handbook Page Hill Phoenix Page Table of Contents General Information Model O5DMA Casters Installation Refrigeration Piping Component Definitions Plumbing Electrical Hookup Electrical Hookup Control Settings To program parameters To Initiate Manual DefrostTo change setpoint To lock and unlock the unitInterface OperationAlarm Operation Control SettingsUser Level Setpoints O5DMA Wiring DIAGRAMS- O5DMAMODEL O5DMA 4’, 6’ & 8’ System Requirements Guidelines & Control SettingsElectrical Data Condensing Unit DataDefrost and Temp Control AIR Flowand Product Loading USE and Maintenance Entire fan basket FansParts Ordering Plug Button End Assembly End KickplateLamp Shield Compressor Shroud Coil Shelf Tag MouldingProcedure Page Page Warranty Maintenance & Case Care