Plumbing

All of the plumbing components are attached to the case at the factory so there is no assembly required. The case drain is located front and center of the cases for convenient access and is specially molded out of ABS material. The “P” trap, furnished with the case, is molded of PVC. Should any future maintenance issues arise care should be given to assure that all connections are water tight and sealed with the appropriate PVC or ABS cement.

The case run-off is channeled to a drain pan located underneath the case as shown below. The water is then pumped up to an evaporative drain pan on top of the case where an electric heater evaporates the run-off. When cleaning the case be sure not to introduce water faster than the drain pump can carry it away.

HEATERS

EVAPORATIVE

DRAIN PANMODEL

O5DMA

DRAIN PAN		CASE DRAIN

DRAIN PUMP