•When the Ice Chute stops over the desired Blending Station, push the toggle switch up to the SHAVE position to add more ice to the Blending Jar.
•Release the SHAVE switch when you have added the desired amount of ice.
•To blend in the additional ice, push the toggle switch down for that Blending Station until the desired consistency is achieved.
•To stop blending, release the toggle switch.
•You can also achieve thicker drinks by reducing any amount of liquid ingredients for the respective recipe.
TO THIN DRINKS:
•Depress the Manual SHAVE/BLEND toggle switch up or down of desired Blending Station for at least two seconds and release if the Chute is not over the desired station. The Ice Chute will rotate to the correct Blending Station and the Green LED light will flash as the Ice Chute is moving.
NOTE: IF THERE ARE NO ACTIONS AFTER THE ICE CHUTE HAS ARRIVED FOR 7 SECONDS AN ORANGE LIGHT WILL FLASH FROM THE START BUTTON FOR 3 SECONDS TO SIGNAL THAT THE ICE CHUTE IS GOING TO MOVE BACK TO THE CENTER (HOME) POSITION.
•When the Ice Chute is in position over the selected Blending Station, push the toggle switch down to BLEND until the desired consistency is achieved.
•To stop blending, release the toggle switch.
•You can also acheive thinner drinks by increasing any amount of liquid ingredients for the respective recipe.
SERVING YOUR FROZEN CONCOCTIONS
19. To serve:
• Lift and remove each Blending Jar.
• Remove the Blending Jar Lid(s).
• Pour and enjoy!
20. To make more drinks, repeat from STEP 7, adding more ice to the Ice Reservoir as needed.
21. During use, periodically check the
Ice Melt Reservoir and empty as needed.
When the Party’s Over
When you are finished using the Margaritaville® Frozen Concoction Maker™, follow these simple steps to remove any remaining ice from the Ice Reservoir.
22. Place an empty Blending Jar in an available Blending Station, then hold that Station’s toggle switch up on the SHAVE setting until the Ice Reservoir is empty.
WARNING: NEVER PLACE YOUR FINGERS IN THE ICE HOPPER. THE SHAVING BLADE IS VERY SHARP AND CAN CAUSE INJURY.
23.
24.
Turn off the unit and unplug.
Empty the Ice Melt Reservoir and wipe dry or allow to air dry.