Cleaning and Maintenance

IMPORTANT: Your Blending Jars, Shaving and Blending Blades are subject to wear during normal use. Always inspect

for nicks, chips, or cracks. Always carefully inspect for broken, cracked, or loose blades. If any of the Jar or Shaving and Blending Blades are damaged, do not use. Call our toll-free customer service number, 1-877-689-2737, to obtain replacement parts.

1. Make sure unit is unplugged. Place on a clean dry surface. Turn the unit so the back is facing you.

Remove the Ice Reservoir Lid by turning clockwise to the unlock position (Figure 1).

2. To remove the Ice Reservoir, push down on the

Ice Reservoir Release Button (Figure 2). Lift the back of the Ice Reservoir and remove. This will expose the Hopper Cover, Shaving Paddle and Ice Hopper.

NOTE: THE SHAVING BLADE IS LOCATED INSIDE THE ICE HOPPER (FIGURE 3).

WARNING: SHAVING BLADES ARE SHARP. DO NOT PLACE FINGERS INSIDE THE ICE HOPPER NEAR THE SHAVING BLADE. BLADE IS SHARP; HANDLE WITH CAUTION.

3. To remove the hopper cover, simply lift up at either cut out area in front of the ice hopper release catches. (Figure 4)

4. To remove the Shaving Paddle, unscrew the Shaving Paddle Thumb Screw counter-clockwise until loosened (Do not separate from shaving paddle), then remove the Shaving Paddle by lifting straight up (Figure 4), exposing the Ice Hopper and Shaving Blade. To reassemble, place the Shaving Paddle back into position, and screw down the Shaving Paddle Thumb Screw clockwise until tightened properly. (Figure 5).

NOTE: THE ICE PADDLE IS KEYED TO MATCH THE SHAFT. MAKE SURE TO ALIGN PROPERLY TO ASSEMBLE.

NOTE: IF THE ICE PADDLE THUMBSCREW IS TOO TIGHT USE THE BOTTOM OF MEASURING CUP TO LOOSEN .

5. Press the two Ice Hopper release catches and lift the Ice Hopper to remove (Figure 6).

PLEASE FOLLOW THE INSTRUCTIONS BELOW TO

SAFELY REMOVE THE SHAVING BLADE ASSEMBLY

FROM THE ICE HOPPER.

-10-

Figure 1

Figure 2

Figure 3

Figure 4