Marvel Industries 61ARMBSFR, 61ARMBSFL manual Full Overlay Panel Installation Instructions, 6ADAM

Page 13

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

Step 1: Verify door alignment

The door should be parallel to the sides and top of the refrigerator. If alignment is necessary the door may be adjusted by loosening the 2 screws which secure the hinge adapter brackets to the door and adjusting the door side to side. Use a 5/32” allen wrench for this pro- cedure. (See Figure 3 below).

Step 4: Cut overlay panel

Depending on the refrigerator model cut the overlay panel to the dimensions shown in Figure 4 and Table A below.

For overlay with lock option panel thickness to be

Hinge adapter screws loos- en these to adjust door, on the top and bottom of the door

Top hinge pin remove to remove the door.

9/32”

(7mm)

3/4” (19mm) maximum to 5/8” (16mm) miniumum.

Weight of the overlay panel should not exceed 20 pounds (9.1 kilograms).

For the door closer to work properly it is necessary to maintain a minimum space of 9/32” (7mm) between the door and cabinet flange as shown . This space can be adjusted by adjusting the top and bottom hinge adapters.

W

 

Door must be

 

parallel to top

Figure 3

and sides of

refrigerator

 

Step 2: Remove door

Remove the top hinge pin from the hinge with an 1/8” allen wrench. Remove the door by angling the top of the door outward and lifting the door off the bottom hinge. (See detail in Figure 3).

Step 3: Remove gasket

Lay the door on its front being careful not to scratch it. Remove the door gasket by peeling up and out of the channel.

Front of

 

 

 

overlay

 

 

 

 

H

panel

 

 

 

 

 

 

 

 

 

 

 

 

Figure 4

Model

W

H

 

 

 

30ARM

14-5/8”

30-5/16”

(37.13cm)

(76.99cm)

 

 

 

 

61ARM

23-5/8”

30-5/16”

(59.99cm)

(76.99cm)

 

 

 

 

6ADAM

23-5/8”

27-11/16”

(59.99cm)

(70.33cm)

 

 

 

 

Table A

Step 5: Clamp panel to door

Set the overlay panel on the door front, align the edges, and clamp together. Clamp the panel firmly but be care- ful not to crush the foam in the door or scratch the door.

12

Image 13
Contents 30ARM 61ARM 3OARM 6OARM 6ADAM MarvelTable of Contents Unpacking Your Refrigerator Installing Your Refrigerator Using Your MicroSentry Refrigerator Control Using Your MicroSentry Refrigerator Control Dimensions for Models 30ARM & 3OARM Dimensions for Models 30ARM with Overlay Door Dimensions for Models 61ARM & 6OARM Dimensions for Model 61ARM with Overlay Door Recommended Rough In Opening Dimensions, Model 6ADAM Dimensions for Model 6ADAMDimensions for Model 6ADAM with Overlay Door 6ADAM Full Overlay Panel Installation InstructionsMaterial Type #8 Wood Screw Right hand Hinges shown Care and Cleaning Troubleshooting Your Refrigerator Household Product Warranty Appendix A, Additional MicroSentry Features EN Rev G 11/10/09