Mabe Canada JGBP86 Installing the ANTI-TIP Device, When ALL Hookups are Completed

Page 53

Installation Instructions

10INSTALLING THE ANTI-TIP DEVICE

WARNING!

Range must be secured with an approved Anti- Tip device.

Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

This range has been designed to meet all recognized industry tip standards for all normal conditions.

The use of this device does not preclude tipping of the range when not properly installed.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

A.Mark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

 

Anti-Tip

 

device

Slotted head

 

screw

Wallplate

 

Approx. 20°

 

2 18Marked edge of range

B. Locate the outside edge of the device 218″ toward the center of the range from the marked edge of the range.

C. Using the device as a template, mark the position of the hole for the screw.

D. For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4″ x 112″ lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

10 INSTALLING THE ANTI-TIP DEVICE (CONT.)

Wallboard

Back of range

 

Anti-Tip device

Wood screw

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

E. Slide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE

COMPLETED

Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the range is unobstructed.

CONVERTING TO LP GAS (or

converting back to natural gas from LP)

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions and LP orifices can be found attached to the range next to the pressure regulator.

Keep these instructions and the orifices in case you want to convert back to natural gas.

53

Image 53
Contents Write the model and serial numbers here Model # Serial # Installation Instructions183D5580P195 All ranges can tip and injury could result Consumer Support TroubleshootingGe.com Safety Instructions Operating InstructionsInstructions Surface Burners Tips Installation Instructions Operating Instructions SafetyTips Consumer Support Upper OvenTroubleshooting Tips Installation Using the gas surface burnersInstructions ConsumerConsumer Support SafetyInstallation Instructions Troubleshooting Tips How to Insert the Griddle Using the griddle. on some modelsUsing the Griddle Becomes seasoned with useSafety Instructions Operating Instructions Installation Using the oven controls. on some modelsInstructions Troubleshooting Tips Consumer Support Consumer Support Troubleshooting Tips Installation InstructionsInstructions Operating Using the upper ovenSupport Troubleshooting Tips InstallationHow to Set the Upper Oven for Broiling Installation Instructions Troubleshooting Tips ConsumerSupport Broiling GuideConsumer Support Troubleshooting Tips Installation Using the clock and timerTo Set the Timer To Set the ClockIf a flashing time is in the display, you have To Reset the TimerTo Cancel the Timer How to Set a Delayed Start and Automatic Stop Safety InstructionsHow to Set an Immediate Start and Automatic Stop How to Set the Upper Oven For Cooking When Using the Probe Using the probe. on some modelsTroubleshooting Tips Consumer Support Convection Bake Using the convection oven. on some modelsConvection Roast Auto Recipe ConversionTroubleshooting Tips Consumer Support Installation InstructionsHow to Set the Upper Oven for Convection Baking or Roasting Multi-Shelf BakingTouch the Convection Roast pad Operating InstructionsMeats Convection Roasting GuideTroubleshooting Tips Using the timed convection baking features. on some modelsInstallation Instructions Operating Instructions Consumer SupportSafety Instructions Special features of your upper oven controlFahrenheit or Celsius Temperature Selection Hour Shut-OffControl Lockout on some models Tips Installation Instructions OperatingCook and Hold Hour, 24-Hour or Clock BlackoutInstructions Troubleshooting Tips Consumer Support Using the Sabbath FeatureHow to Set for Regular Baking/Roasting Safety InstructionsHow to Exit the Sabbath Feature Safety Instructions Adjust the upper oven thermostat-Do it yourselfTo Adjust the Thermostat Type of margarine will affect baking performanceWhen Using the Warming Drawer Using the electric warming drawer. on some modelsWarming drawer cannot be used during a self-clean cycle To Use the Warming DrawerTemperature Selection Chart Instructions Operating Instructions InstallationTo Crisp Stale Items To Warm Serving Bowls and PlatesTo Use the Lower Oven Drawer Using the lower oven drawer. on some modelsWhen Using the Lower Oven Drawer Warm Zone Instructions Operating Instructions Installation Using the self-cleaning upper ovenInstructions Troubleshooting Tips Consumer Support Before a Clean CycleConsumer Support Troubleshooting Tips Using the self-cleaning ovenInstallation Instructions Operating Instructions Safety After a Clean CycleBurner Assemblies on some models Care and cleaning of the rangeTroubleshooting Tips Consumer Support Burner Caps and Heads Griddle Installation Instructions Troubleshooting TipsBurner Grates Cooktop SurfaceOven Air Vents Consumer SupportUpper Control Panel Stainless Steel Surfaces on some modelsLift-Off Oven Door Troubleshooting TipsOven Bottom Broiler Pan and GridOven Light Replacement Installation Instructions OperatingTips Oven Shelves and Drawer RacksRemovable Drawer Warming Drawer Models only Removable Lower Oven Drawer PanTo remove the drawer To replace the drawer Removable Drawer Lower Oven Drawer Models onlyMaterials YOU MAY Need For Your SafetyTools YOU will Need Electrical Connections in this section Installation InstructionsDimensions and Clearances Location ANTI-TIP DeviceConnect the Range to GAS Provide Adequate GAS SupplySee the below section for models JGB916 and JGB918 GAS Pipe and Electrical Outlet LocationsRigid Pipe Hookup Options Flexible Connector HookupElectrical Requirements Electrical ConnectionsSeal the Openings Assemble Surface BurnersCheck Ignition of Oven Burner Check Ignition of Surface BurnersTo remove the oven bottom Leveling the RangeWhen ALL Hookups are Completed Installing the ANTI-TIP DeviceProblem Possible Causes What To Do Before you call for service…Operating Instructions Safety Instructions See the Installation of the range section See the Using the upper oven sectionSee the Adjust the upper oven thermostat-Do it Clock and timerOven not clean after a After a clean cycleClean cycle Is on when you wantDisplay goes blank Power outageDisplay flashes Unable to getLooking For Something More? AccessoriesWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Operating Instructions Installation Instructions Consumer Support Troubleshooting Tips Installation Instructions Safety InstructionsGE Will Replace What GE Will Not CoverInstructions Installation Safety Instructions OperatingMabe Will Replace What Mabe Will Not CoverConsumer Support Schedule Service