Norcold 482, 483, 463, 453, 443, 462 Check Out Flame Failure Safety Device, Door Panel Installation

Figure 11

Check Out - Flame Failure Safety Device

Before placing the refrigerator into operation, the gas safety device must be tested (see Operating In- structions on page 13). The purpose of the gas safety device is to prevent the escape of unburned gas from the burner if the burner flame is extin- guished. Once a flame is established, close the man- ual shut-off valve of the refrigerator. The flame will extinguish and ignition spark will continue. Wait a minimum of four (4) minutes and re-open the manual shut-off valve. The burner flame will not re-establish, indicating the gas safety control is functional.

Door Panel Installation

The Norcold refrigerator doors provide slots for in- serting decorative panels. Installation of the panels is accomplished by removing the handle assembly, in- serting the decorative panel, and re-inserting the handle assembly. This procedure applies to both doors. (See Figure 12)

The frame slots are designed to accept panel thick- ness up to 3/16" maximum.

TABLE 4

PANEL DIMENSIONS

462, 463	482, 483
Upper Door 19 11/16" x 16"	19 11/16" x 16"

Lower Door 19 11/16" x 32 1/4" 19 11/16" x 39 1/4"

442, 443 452, 453

Door Panel 19 11/16" x 27 1/4" 19 11/16" x 39 1/4"

Figure 12

INSTRUCTIONS

1.Prepare panel by cutting to size indicated in ac- companying chart. (See TABLE 4)

2.Remove handle assembly (A) by removing four screws (B). (See Figure 12)

3.Slide panel into frame slots.

4.Replace the handle assembly.

Instructions for Reversing Door Swing

Your refrigerator is equipped with convertible door hinges. The hinging of the doors can be changed to the opposite side anytime you wish.

TOOLS REQUIRED

Phillips Screwdriver - Size #2

Two Slotted Screwdrivers

REMOVING THE DOORS

1.Remove all items of food, juices, etc., from the doors. Remove the juice rack and storage bins. Close both doors before removing hinge pins.

2.Remove the top hinge pin using one of the slot- ted screwdrivers. Remove the center hinge pin (both pieces) using the two slotted screwdriv- ers; one on each end of the pin. Lastly, remove the bottom hinge pin. Be sure to save the pins for reassembly later. (See Figure 19)

Figure 13

3.Remove the upper door by opening the door slightly and pulling the bottom of the door away from the refrigerator. Allow enough room to slide the door down off of the upper hinge pin shoulder. (See Figure 13)

11