Norcold 482, 483, 463, 453, 443 Electrical Circuits AC and DC, Refrigerant System, Child Entrapment

Page 3

Safety Precautions - continued

Electrical Circuits - AC and DC

The 120 volt AC circuit must be properly grounded. Never cut or remove the round grounding prong from the refrigerator’s AC cord. Do not use a two-prong adapter. Do not use an extension cord to connect to the approved AC receptacle.

Protect all wiring from physical damage, vibration, or excessive heat.

Always disconnect both AC and DC sources of power when working on either circuit (only a qualified service person).

Insure all terminating connections are clean and tight to prevent arcing or over- heating.

Never allow Leak Detecting fluids or any other liquids to spill on electrical connec- tions. Many liquids are electrically conductive and could cause serious arcing dam- age and, in some case, fires.

Refrigerant System

Never physically bend, drop, drill, weld, or hammer the refrigerant system. Doing so could cause the system to rupture and release dangerous chemicals which can cause severe burns to the eyes or skin. If ignited, these chemicals will burn with intense flame. A leaking system can release certain chromium components which, if inhaled, can cause cancer.

Never apply direct heat in excess of 240° F to the refrigerant system. Because the refrigerant is hermetically sealed under pressure, a temperature sensitive safety de- vice opens to protect the system from erupting under excessive pressure. However, the expelled refrigerant could ignite and burn if an ignition source were near.

Never attempt to repair or recharge the refrigerant system. If defective, it must be replaced.

Child Entrapment

Never install door locks or other restraints which could entrap small children within the refrigerator. The Travel Latch system must not be modified.

Handling the Refrigerator

Never lift the refrigerator without assistance. Protect yourself from body strain.

Avoid hot surfaces at the rear of the refrigerator when operating. The absorption type refrigerator produces several hot areas at the rear of the unit. This is true whether in GAS or ELECTRIC mode.

Take care to avoid brushing against the irregular shapes and sheet metal parts at the rear of the refrigerator. Cuts or abrasions could result.

3

Image 3
Contents For Your Safety Installation and Operating InstructionsGeneral LP Gas SystemExhaust Gases Handling the Refrigerator Electrical Circuits AC and DCRefrigerant System Child EntrapmentGeneral Instructions All Models Extended Cooling Unit Service Protection PlanNorcold BOX Sidney OHCertified Vent Kits Ventilation RequirementsOptimum Installation Figure Exhaust Vent Centered FigureAlternate Construction Requirements Figure Top and Side Wall Clearance-All Models Side Wall Clearance FigureInstallation Instructions Gas Connection Volt AC ConnectionVolt DC Connection Hypot Test Testing the Vehicle’s Gas Supply PipingVolt Supply Wiring and Fuse Size Chassis Bonding ConnectionCheck Out Flame Failure Safety Device Door Panel InstallationInstructions for Reversing Door Swing Relocating the Travel Latches Removing and Relocating the Hinge BracketsAlignment of the Doors Operation Shut-Down All Modes Way and 3-Way Models Lighting Instructions Gas OperationStart-Up Instructions AC Electric Operation Start-Up Instructions DC Electric Opera- tion 3-Way modelsOperating and User Instructions Interior Light-Models 482,3 & 462,3 Only High Humidity Storage Switch Models 482,3 & 462,3 OnlyInformation Regarding Battery Drain Refrigerator Storage VolumeFreezer Compartment Defrosting and Cleaning the Refrigerator InteriorRefrigerator Maintenance LevelingRefrigerator Storage Refrigerator1. Removal and ReplacementTo Reinstall the Refrigerator Checking Door SealsTrouble Shooting GE Part Number 214-2 do not Substitute Service InformationReplacement Parts Failure of RefrigerationPage Page Norcold Service Center Limited Warranty