-Clean the orifice assembly with air pressure and alcohol only.
-Using a wrench, assemble the orifice assembly to the burner.
-Assemble the flare nut to the orifice assembly.
-Examine all of the connections for gas leaks.
-Clean the burner box.
-Assemble the burner box cover.
-Assemble the drip cup.
Remove the Refrigerator
Your dealer or Norcold authorized service center must do this procedure.
CAUTION: The rear of the refrigerator has sharp edges 
and corners. To prevent cuts or abrasions when working on the refrigerator, be careful and wear cut resistant gloves.
1. Close the valve at the propane gas tank(s).
WARNING: To avoid possible propane gas leaks, 
always use two wrenches to loosen and tighten the gas
supply line connections.
2.Remove the black AC power cord and the white ice maker AC power cord (model
3.Remove the DC wiring from the refrigerator:
-Put a mark on the DC wires so you can put them back in the correct location.
-Remove the DC fuse or remove the DC wiring from the battery or the converter.
-Remove the DC wires from the refrigerator.
4.Open the lower intake vent and remove the gas supply line from the bulkhead fitting of the refrigerator.
5.Remove the plastic plugs from the mounting flanges of the refrigerator.
6.Remove the screws from the mounting flange at the rear of the refrigerator.
7.Remove the screws from the upper and lower mounting flanges on the front of the refrigerator.
8.Remove the refrigerator from the opening.
Reinstall the Refrigerator
Your dealer or Norcold authorized service center must do this procedure.
WARNING: Make sure the combustion seal is not 
broken, is completely around the refrigerator mounting flanges, and is between the mounting flanges and the wall of the enclosure. If the combustion seal is not complete, exhaust fumes can be present in the living area of the vehicle. The breathing of exhaust fumes can cause dizziness, nausea, and in extreme cases, death.
1.Push the refrigerator completely into the enclosure.
2.Install the screws in the upper and then the lower mounting flanges on the front of the refrigerator.
3.Install the screws in the mounting flange at the rear of the refrigerator.
4.Put the plastic plugs into the mounting flanges of the refrigerator.
WARNING: To avoid possible propane gas leaks, always use two wrenches to loosen and tighten the gas supply line connections.
5.Attach the gas supply line to the bulkhead fitting of the refrigerator.
6.Open the valve at the propane gas tank(s).
WARNING: Do not allow the leak checking solution to touch the electrical components. Many liquids are electrically conductive and can cause electrical shorts and in some cases, fire.
7.Examine the gas supply line for leaks.
8.Connect the DC wiring to the refrigerator:
-Connect the DC wires to the refrigerator.
-Install the DC fuse or connect the DC wiring to the battery or the converter.
9.Connect the black AC power cord to the receptacle.
Replacement Parts
You may purchase replacement parts through your local RV dealer or authorized Norcold Service Center.
Owner’s Manual 10