Install the FRONT HOOP POLES (fig. 7)
10.Insert the front hoop side poles [H] first into each assembled front pole [D1, D2] on the frame. Insert another pair of front hoop side poles into the one installed on the front poles. Finish by carefully inserting the front hoop top pole [I] into both the top most front hoop side poles, forming a curve. The curved poles will be standing quite high up in the air. This is normal. (Fig. 7)
Note: The front hoop side poles each have a metal/PVC sleeve on one end. The front hoop top pole DOES NOT have a sleeve on either end. During assembly, make sure the poles end with the PVC sleeves face up.
CAUTION: Use care when assembling the front hoop side and top poles. Poles under tension can slip out of the metal/ PVC sleeves causing serious injury
Install the fabric cab skin to the assembled frame (fig. 8)
11.Unfold the fabric cab skin [Q] and find the pocket sewn into the top rear part of the cab skin roof. Carefully insert the top curved section of the assembled front hoop poles into the pocket on the cab skin. The front hoop poles and roof of the cab skin will rest on top of the assembled frame
hoop poles. (Fig. 8)
12.Unfold the rest of the cab skin and drape over the assembled frame as shown.
CAUTION: No part of the fabric cab skin should touch the engine or exhaust system of your snow thrower.
Note: The lower front panel features two double zippers that allow convenient pass- through of cables or linkages if necessary
Fig. 8
I
H
H
H
H
Fig. 7
8
