Install the center and side mounting bars (fig. 5)
5.Slide side mounting bars [B1, B2] through each upper mounting post. Connect the center mounting bar [A] to both side mounting bars by engaging the spring loaded pins as shown. (Fig. 5)
6.Snug but do not fully tighten. Leave the nuts loose for final adjustments of the mounting posts. Tighten set screws on the lower mounting posts with supplied Allen wrench [P]. Fig. 4
Assemble the rest of the frame (fig. 6)
7.Insert the mounting bar ends [C1, C2] into the side mounting bars by engaging the spring load pins.
8.Install each front pole [D1, D2] into the protruding stud on the top of each side mounting bar.
Note: You must first remove the protective plastic caps off the protruding studs on each side mounting bar [B1, B2].
9.Insert the back hoop side poles [E] first into each side mounting bars. Insert another pair of back hoop side poles into the tops of the ones installed on the side mounting bars. Insert the back hoop corner poles [F] into the tops of the installed sections of back hoop side poles. Finish by inserting the back hoop top pole [G] into both back hoop corner poles.
Note: It may help to place the parts flat on the ground for easier assembly.
Note: The back hoop side and corner poles each have clear plastic sleeves on one end. The frame
hoop top pole DOES NOT have |
|
clear plastic sleeves. | D1 |
|
Remove protective plastic caps from these metal studs prior to assembly
B2
B1
A
Fig. 5
F
G
E
F
E
E
Fig. 6
C1 | E |
D2
C2
7
