Classic Accessories 08CH56_10159 manual Preparation, Assembly instructions

PREPARATION

Before beginning assembly, installation or operation of the product, make sure all parts are present. Compare parts with the package contents list and diagram. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for replacement parts.

Estimated Assembly Time: 30-40 minutes

Tools Required for Assembly:

• Adjustable wrench or one 1/2 in. box end or socket wrench

Assembly instructions

Install the mounting post Clamps (Figs. 1 and 2)

1.Insert two U-bolts [P] around the Snow Thrower frame and through the mounting post clamp spacer [M1, M2] and the mounting post clamp [L1, L2] as shown. (Fig. 1)

Note: Exact positioning may vary depending on manufacture.

2.Install two Nylock nuts [O] to each U-bolt. Snug but do not fully tighten. Leave the nuts loose for final adjustments of the mounting posts. (Fig. 2)

Note: In some instances, it may be necessary to mount the top U-bolts above the handlebar crossbar support. (Fig. 2b)

This will help the assembled cab sit higher for added clearance.

Repeat on other side.

CAUTION: Position of the clamps may vary depending on Snow Thrower Manufacturer

Front side of snow thrower handlebar upright

L

M

CAUTION: Make sure nothing interferes with the safe operation of your snow thrower

Fig. 1

Top U-bolt

may need to be on top of handlebar crossbar.

Fig. 2 Fig. 2b

5