Vinotemp WM1500 HTD-TE, WM2500 HTD-TE manual Installation Instruction, Cabinet Location

Page 6

Installation Instruction

1.Cabinet Location

Place the wine cabinet in a properly ventilated location. Otherwise, heat exhausted by the cooling unit will build up and it will not operate properly.

The exhaust area must not be closed space and must be ventilated. The ambient temperatures shall not be higher than 90 °F or lower than 50 °F.

1) Rear Exhaust Location

Leave min 6 “clearance from the rear to the wall.

Leave min 12” clearance from the top to the ceiling.

Leave min 6” clearance from the left and right sides.

2) Front Exhaust Location

Leave min 6” clearance from the front if left and right sides unobstructed.

Or, leave min 36” clearance from the front if left and right sides obstructed

3) Top Exhaust Location

Leave min 12” from the top to the ceiling.

Leave min 2 “clearance from the rear to the wall.

Leave min 2” clearance from the left and right sides.

4) Side Exhaust Location

Leave min 6 “clearance from the left or right side to the wall.

Leave min 12” clearance from the top to the ceiling.

2.Installation

Fig. 2.1 COOLING UNIT MOUNTING

- 5 -

Image 6
Contents WINE-MATECooling Unit Use & Care Manual Important Safety Information Table of Contents Feature Description Feature DescriptionCFM Installation Instruction InstallationCabinet Location Located AT the Cabinet TOP Exhaust Gasket Electrical CordTemperature Control & Humidity Adjustment Temperature SettingAlarm Signals Humidity Adjustment Manual Defrost Care Guide Component IdentificationII. Condenser Coil Cleaning III. Moisture RemovingTroubleshooting High or not BlinkingBeeping CoolingTripping Water leakCircuit NoisyWiring Diagram Calling Feature Wiring DiagramCustomer Support Warranty Limited WarrantyService under Warranty Limitation of Implied Warranty