Vinotemp WM2500 HTD-TE, WM1500 HTD-TE manual TOP Exhaust Gasket, Electrical Cord

Page 8

Fig. 2.3 TOP EXHAUST GASKET

(LOCATED ON THE COOLING UNIT)

Cut a rectangular inside opening at the rear of the cabinet with the 1/4” clearance inwards to the width and height of the cooling unit. By not going through, leave 1/2” lip inside at the wall to place the gaskets (see Fig. 2.2).

If top exhaust, cut another rectangular opening at the top of the cabinet to the length and width of the top exhaust (see Fig.2.2).

Make 2 holes at the ceiling to install the 1/4 inside diameter wood thread inserts (see Fig.2.2).

Place the gaskets (1) on the gasket lips (see Fig 2.1).

If top exhaust, place another gaskets along the top exhaust at the top of the cooling unit (see Fig.2.3).

Place the cooling unit to a flat and stable place.

Then move it on the top of the wine rack temporally.

Move the cooling unit towards the mounting sides and push to press the gaskets.

Fasten the 2 brackets and use 7/16” wrench to tighten the 2 screws (see Fig 2.1).

If top exhaust, install another top exhaust grille at the top of the cabinet.

Plug the cooling unit in receptacle.

Plug the wine cabinet.

NOTE: DO NOT INSTALL ANY DUCTS ONTO THE SUPPLY, INTAKE ANY EXHAUST.

3.Electrical Cord

Because of potential safety hazards under a certain condition, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it will be a UL LISTED 3-wire grounding type appliance extension cord having a 3- blade grounding plug and a 3-slot receptacle that will plug into the appliance. The marked rating of the extension cord shall be 115 V, 15 A.

-7 -

Image 8
Contents WINE-MATECooling Unit Use & Care Manual Important Safety Information Table of Contents Feature Description Feature DescriptionCFM Cabinet Location Installation InstructionInstallation Located AT the Cabinet TOP Exhaust Gasket Electrical CordTemperature Control & Humidity Adjustment Temperature SettingAlarm Signals Humidity Adjustment Manual Defrost Care Guide Component IdentificationII. Condenser Coil Cleaning III. Moisture RemovingTroubleshooting Blinking BeepingHigh or not CoolingWater leak CircuitTripping NoisyWiring Diagram Calling Feature Wiring DiagramCustomer Support Service under Warranty WarrantyLimited Warranty Limitation of Implied Warranty