START-UP PROCEDURES
•Plug the cabinet into the electrical outlet; operate the cooler for at least three hours. This will aid in refrigeration performance.
•Do not adjust the temperature control. The temperature control is factory set to provide maximum performance.
LIGHT CONTROL
•The inside light is controlled by the power. When unit has power, the light will turn on.
MAINTENANCE
Cleaning
•Before cleaning the appliance always remember to unplug it.
•Unplug the cooler at the electrical outlet; never pull the service cord.
•Do not use sharp or pointed objects for cleaning.
•Clean the inside cabinet of the cooler with a clean damp cloth or with neutral soap. Avoid damage by never using abrasive or flammable cleaning products.
•Clean the condenser at least once a month with a vacuum cleaner or a
brush to eliminate the dust accumulation.
Light replacement
•Unplug the cooler or cut off power before removing the light.
•Remove the screw.
•Remove the light cover gently.
•Remove the light.
•Replace the light with a bulb of the same size and shape.
•Install the light cover and tighten the screw.
Power failure
•Please minimize the frequency of opening the door during a power failure. Most power failures are corrected within a few hours and the temperature of your cooler will not be affected.
•If the power will be off for an extended period, proper procedure should be followed for the stored cans.
Nonuse for extended time frames
•If your cooler will be unused for an extended period of time, it is best to remove the cans, unplug and clean your cooler. Also please open the door to avoid possible formation of condensation, mold or odors.
Moving the cooler
•Take out all the cans.
•Secure all loose parts inside the cooler.
•Tape the door shut.
•During transportation, make sure that the cooler remains in an upright position.
6 | W W W . V I N O T E M P . C O M |