U-Line 2275DWRCOL, 2275DWRW Anti-Tip Kit Installation, Installation Troubleshooting, Install Unit

Page 15

11Install Unit

1.Plug in the power cord.

2.Open the top drawer and press the POWER icon to turn the unit OFF.

3.C2275DWR Only: Open the water supply valve in the main water source.

4.Gently push the unit into position. Be careful not to entangle the electrical cord.

5.Re-check the leveling, from front to back and side to side. Make any necessary adjustments. The unit’s top surface should be approximately 1/8" below the countertop.

Anti-Tip Kit Installation

WARNING

The Anti-Tip Kit must be installed on this unit before it is used.

Additional blocking or special fasteners may be required for installation. Installer is responsible for secure attachment to prevent the unit from tipping.

Make sure the mounting screws attaching the unit to the counter, cabinet or wall are deep enough into the mounting surface to support the weight of the drawers and the items that will be inside the drawers.

Never use the drawers as steps or as a shelf to support more than the drawers’ content. Serious personal injury could occur.

After leveling, the unit must be secured to a counter, a cabinet or a wall to prevent tipping.

1.Open the upper drawer to expose the six screws (A) installed at the top two corners (three at each corner). Remove the appropriate screws for horizontal or vertical mounting Do not discard.

Horizontal Mounting

Countertop or Wall Header

 

(Left Side Shown)

 

 

B

 

A

 

C

Vertical Mounting

Cabinet or Wall Stud

(Left Side Shown)

 

 

B

C

A

2.Insert the screws through the anti-tip bracket (B) and attach the bracket to the unit. Tighten screws securely.

3.Repeat for the other side.

Note: The bracket should be flush with the surface it is being attached to. If it is not, loosen the screws and slide the bracket against the mounting surface. Tighten screws securely.

4.Using two of the screws (C) supplied, fasten the screws through the bracket and into the counter, cabinet or wall.

IMPORTANT

Certain cabinets or countertops may require special fasteners or additional wood blocking to anchor properly.

CAUTION

Make sure the screws are back far enough so they do not

damage any exposed front surface of the cabinet.

Installation Troubleshooting

Q: Problem

The drawer remains open unless it is pushed closed.

A:Solution

The drawer should be self-closing when it is open approximately 8". If it is not, re-check leveling from front to back of the unit and readjust if necessary.

Q: Problem

Water is leaking under the unit (C2275DWR units)

A:Solution

A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly.

U-Line Electrical / Plumbing Specfications

13

Image 15
Contents Install Guide Table of Contents Safety Alert Definitions General PrecautionsSafety Precautions Tools / Material Required Exterior CleaningProduct Registration Models Covered InspectionPrepare Site 2275DWRC Series C2275DWR Series2275DWRW Series C2275DWR Product Dimensions2275DWRC 2275DWRWWater Supply Power SupplyOther Site Requirements Clearance InformationAdjusting Drawer Alignment Checking Drawer AlignmentStandard Drawers Top-to-Bottom and Left-to-Right Adjustment Re-installation of DrawerFull Overlay Drawer Panels Drawer Panel InstallationDrawer Panel Installation Custom 1/4 Drawer Panel InsertsAttaching the Full Overlay Panel Preparation InstallationGrille Overlay Wood Grille OverlayGrille Overlay Dimensions 24 Inch Models Installation Tip Water Supply ConnectionPrepare Plumbing Level The Unit Anti-Tip Kit Installation Installation TroubleshootingInstall Unit First Time Start Up Start-Up TroubleshootingInstallation Guide