Product Registration Models Covered, Inspection

3 Inspect & Plan

Product Registration

You have received a carton containing your U-Line Combo Drawer Model Ice Maker/Refrigerator or U-Line Refrigerator with a package inside containing a Use and Care Guide, a Product Registration Card, water connection parts and Anti-Tip Kit. Complete and mail the Product Registration Card or register online at www.U-LineService.com. Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference.

Models Covered

This installation guide covers the following models

U-2275DWRCOL-00	U-2275DWRWS-00
U-2275DWRCS-00	U-C2275DWROL-00
U-2275DWRWOL-00	U-C2275DWRS-00

Inspection

Inspect the unit on a flat, level surface capable of supporting it’s entire weight.

Removing Protective Coating

All Models:

The protective coating covering the inside of the top drawer must be removed before using.

Stainless Steel Models:

When inspecting/installing a Stainless Steel unit, the protective coating covering the drawer fronts must be removed. Start at a corner of the drawers and pull back the protective coating to remove it from the drawer fronts.

After all the protective coating has been removed from the drawers, clean all Stainless Steel surfaces with Claire Stainless Steel Polish and Cleaner or comparable product or a mild detergent and warm water solution and soft cloth. Do NOT use abrasive cleaning agents.

If cleaning with mild detergent and warm water solution and soft cloth, the unit MUST be treated with Claire Stainless Steel Polish and Cleaner or comparable product to prevent discoloration.

Tools / Material Required

•Screwdrivers — slotted and Phillips head (If installing a 3/4” Full Overlay panel)

•3/4” overlay frame material

•Cutting Tools

•Drill & Drill Bits

(If installing 1/4” Panel Insert)

•1/4” thick door panel material

•Cutting Tools

Exterior Cleaning

Overlay Models:

•The drawers, grille and cabinet may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spotting.

Stainless Models:

•Stainless steel models can discolor when exposed to chlorine gas, pool chemicals, salt water or cleaners with bleach.

•Keep your stainless steel unit looking new by cleaning with a good quality all-in-one stainless steel cleaner/polish on a monthly basis. For best results use Claire Stainless Steel Polish and Cleaner, which can be purchased from U-Line Corporation. (The part number is 173348.) Comparable products are acceptable. Frequent cleaning will remove surface contamination that could lead to rust. Some installations may require cleaning on a weekly basis.

•Do not clean with steel wool pads.

•Do not use cleaners that are not specifically intended for stainless steel (this includes glass, tile and counter cleaners).

•If any surface discolors or rusting appears, clean it quickly with Bon-Ami or Barkeepers Friend Cleanser and a non-abrasive cloth. Always clean in the direction of the grain. Always finish this process with Claire Stainless Steel Polish and Cleaner or comparable product to prevent further problems.

•Use of abrasive pads such as Scotchbrite will cause the graining in the stainless to become blurred.

•Rust that is allowed to linger can penetrate into the surface of the stainless steel and complete removal of the rust may not be possible.

WARNING

Rust that is allowed to linger can penetrate into the surface of the stainless steel and complete removal of the rust may not be possible.

U-Line Inspect & Plan