Re-installation of Drawer

Minor Adjustment:

Note: The mounting holes on the slide are slightly larger than the screws’ diameter.

Screws Should

Be Loose

Minor Adjustment:

Note: The mounting holes on the slide are slightly larger than the screws’ diameter.

1.Loosen one slide’s mounting screws.

2.Level the slide.

3.Retighten the screws. See Figure 18.

4.Repeat procedure for the other slide.

Severe Adjustment:

Level the Slide

1.Loosen one slide’s mounting screws.

2.Push the slide upward or downward to match the position of the other slide.

3.Retighten the screws.

4.Repeat the procedure with the other slide if necessary.

Severe Adjustment:

Mounting Screws

Push Slide

Upward or

Downward

Note: The slides have extra mounting holes that may be used.

1.	Loosen one slide’s rear	Mark and Drill New
	mounting screws.	Mounting Holes
2.	Remove the slide’s front
	mounting screws.
3.	Reposition the slide so it is
	level.
4.	Mark new front drilling holes	Level the Slide
	using a different set of

mounting holes on the slide.

5. Drill the new holes with a #30 drill bit.

1.Remove one slide’s mounting screws.

2.Reposition the slide so it is the same distance from the bottom of the liner as the other slide. Measure to confirm.

3.Mark new drilling holes using different sets of mounting holes on the slide. See Figure 22.

Mark and Drill New

Mounting Holes

Push Slide

Upward or

Downward

6.	Remount the slide.
7.	Repeat procedure for the other slide.

Top-to-Bottom (and Left-to-Right) Adjustment

Not Aligned

Top-to-Bottom

Not Aligned Left-to-Right

FrontView of Unit

TopView of Unit

The drawer will need a Top-to-Bottom Adjustment if, when viewed from the front, the drawer is not level horizontally. Viewed from the top, one side will protrude. This is caused by one of the slides being mounted higher than the other slide on the unit’s liner.

Note: Front location holes are shown. Corresponding rear holes will also need to be marked.

4.Drill all the new holes with a #30 drill bit.

5.Remount the slide.

CAUTION

Use care when handling the drawer. Drawer edges, drawer rail and the unit’s slide may be sharp.

1.Set the drawer’s rails onto the slides.

2.Re-install the rails’ mounting screws. See Figure 13 on Page 10.

3.Plug in the drawer’s connection wiring (top drawer only).

U-Line Drawer Alignment