U-Line U-CO2175FS-00, U-2175RFS-01, U-2175RFS-00, U-2175RFW-00, U-CO29B-20 Adjusting Air Temperature

Page 10

Adjusting Air Temperature

Combo Models

NOTICE

•Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.

•Factory recommended set-point is between 3 & 4 on the dial control.

To adjust the set point temperature:

Adjust the temperature by turning the numbered dial (1) in small increments.

12

Checking Product Temperature

To check the actual product temperature in the unit:

1.Partially fill a plastic (nonbreakable) bottle with water.

2.Insert an accurate thermometer.

3.Tighten the bottle cap securely.

4.Place the bottle in the desired area for 24 hours.

5.Avoid opening the unit during the testing period.

6.After 24 hours, check the temperature of the water. If required, adjust the temperature control in a small increment (See

ADJUSTING TEMPERATURE).

Causes which affect the internal temperatures of the cabinet include:

•Temperature setting.

•Ambient temperature where installed.

•Installation in direct sunlight or near a heat source.

•The number of door openings and the time the door is open.

•The time the internal light is illuminated. (This mainly affects product on the top rack or shelf.)

•The front grille or condenser are obstructed.

u-line.com

7

Image 10

Contents 2175RFS-01 2175RFB-002175RFS-00 2175RFW-00Read and save this Use and Care Guide Please Record Your Model InformationTable of Contents Safety Alert Definitions General PrecautionsCombo Model Features Ice Makers FeaturesAir Flow Adjusting Air TemperatureControl Systems Initial StartupTo check the actual product temperature in the unit Checking Product TemperatureInterior Lighting Electronic Control Quick Guide TouchControl Dial To turn the unit on or offAdjusting Air Temperature Crispers DrawersTop Storage Bin Ice Maker Operation Ice Maker AdjustmentInterval As Required Removing and Installing Interior Shelves LevelingRemoving and Installing Door Shelves Removing and Installing GrilleInstalling the grille To align and adjust the door Door Alignment and AdjustmentDoor Systems Door Reversability Reversing Black or White DoorsInstall Door Prepare door for reinstallationAlign and adjust the door Remove top hinge, and door Reversing the DoorTo reverse the door Remove grille Remove bottom hingeInstall top hinge, and door Install bottom hingePrepare door for reinstallation For black or white doors Install grilleAdjusting Drawer Alignment Checking Drawer AlignmentRe-installation of Drawer Top-to-Bottom and Left-to-Right AdjustmentInterior Cleaning Exterior CleaningDefrosting Product Disposal Condensor CleaningStorage, Vacation and Moving Interval Every Three MonthsReplacement Parts Before Calling for ServiceIf Service is Required Troubleshooting GuideDESIGNED, Engineered and Assembled in WISCONSIN, USA