2175BEV/2175BEVOL2 Beverage Center
PREPARE THE NEW OVERLAY PANEL
IMPORTANT
The overlay door panel must not weigh more than 20 lbs. The thickness of the door panel must be 3/4".
1.Place a towel, or other similar, soft,
2.Lay the wood panel out with the front side of the wood facing down.
3.Cut the foam tape into four pieces, two pieces the width of the overlay and two pieces the height of the overlay.
4.Remove adhesive protection strip from one piece of the cut foam and align the edge of the foam tape to the inside edge of the overlay as shown, adhering the foam tape to the overlay (Figure 14).
Figure 14
5.Trim each piece of tape immediately after applying it to the overlay. Do not allow any overlapping of the foam tape. Damage to the overlay can occur if the foam tape is not trimmed correctly (Figure 14).
6.If required, attach any optional cabinet hardware to the wood panel at this time. If an optional cabinet handle is installed, make sure the mounting screw heads are below (countersunk) the back surface of the overlay.
Note: After attaching the optional cabinet hardware, additional supports may be needed to keep panel flat for next steps.
ATTACHING THE OVERLAY PANEL
7.Remove the top hinge pivot pin with a Phillips screwdriver and lift door off bottom hinge pin (Figure 15). Be careful not to lose the door closer insert sets. Save pivot pin for use later.
Figure 15
8.Carefully lay the door over the wood panel, making sure door is orientated correctly (top of door with top of wood overlay).
9.Pull door gasket out of the groove completely. Start in the middle and pull outward, moving towards the corners (Figure 16). This may take some force, but be careful not to cut or rip the gasket.
Figure 16
10.After gasket has been removed, place it on a flat, clean surface.
11.Secure door to the back of the wood overlay using tape on all four corners. Make sure all four edges are aligned (Figure 17).
03/2008 | 11 |