Smeg WT112-1, WT1123-1 instruction manual Water loaded accurately. Interrupt the program

Page 10

User instructions

E7

E8

E9

FAULT

DESCRIPTION

 

 

 

 

Turbine flow-regulator malfunction (for the

 

relevant models only)

 

 

The appliance is not able to "measure" the amount

 

of water loaded accurately. Interrupt the program

 

and switch off the dishwasher. Switch the

 

dishwasher back on, program it again and start

 

the washing cycle. If the problem persists, contact

 

the after-sales service.

 

 

 

 

Alternate washing system malfunction

 

Interrupt the program and switch off the dishwasher.

 

Switch the dishwasher back on, program it again and

 

start the washing cycle. If the problem persists,

 

contact the after-sales service.

 

 

 

 

Water intake system malfunction

 

Contact the after-sales service.

 

Light off

Light on

Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.



Image 10
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Setting the Washing Program and Switching onUpper panel 110 Washing programs Table for Certification BodiesCancelling the Current Program Changing the ProgramAdjusting the Water Softening System Water Hardness TableEND of Cycle Removing the DishesTroubleshooting Fault DescriptionWater loaded accurately. Interrupt the program For Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Appliance Installation instructions Installation and hook-upWater supply connection Connecting to the Water SupplyDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionCleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Cleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598