Smeg WT112-1, WT1123-1 instruction manual Before Starting the Dishwasher After Prolonged Disuse

Page 36

User instructions

BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:

•Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.

•Plug the power cord back into the socket.

•Reconnect the water intake hose and open the tap again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:

If the program fails to start, check that:

•the dishwasher is connected to the electrical power supply;

•there is no power failure;

•the water tap is open;

•the dishwasher door is properly closed.

If water remains inside the dishwasher, check that:

•the drain hose is not kinked;

•the drain siphon is not obstructed;

•the dishwasher filters are not clogged.

If the dishes are not being cleaned properly, check that:

•the correct amount of detergent has been added;

•there is regenerating salt inside the special container;

•the dishes are being loaded correctly;

•the selected program is suitable for the dish types and their degree of soiling;

•all the filters are clean and positioned correctly;

•the spray arm nozzles are not obstructed;

•there is no object obstructing the rotation of the spray arms.

Image 36

Contents Guide for Using the Dishwasher and the Washing Programs Contents Setting the Washing Program and Switching on Description of the controlsUpper panel 110 Washing programs Table for Certification BodiesCancelling the Current Program Changing the ProgramAdjusting the Water Softening System Water Hardness TableEND of Cycle Removing the DishesTroubleshooting Fault DescriptionWater loaded accurately. Interrupt the program For Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Appliance Installation instructions Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598