INSTALLATION
6) ELECTRICAL CONNECTIONS
Electrical connection must be carried out in compliance with the specifications and provisions in force.
Before proceeding with the connections, check that:
-The voltage rating of the appliance and the current sockets suits the maximum power draw of the appliance (see data label affixed to the lower part of the appliance itself).
-The system is equipped with an efficient earth connection in compliance with the pertinent provisions in force. The manufacturer declines all responsibility for failure to comply with these provisions.
-If the appliance has no power cable, connect a cable of adeguate section to the terminal strip (consult the table on next page) complying with
the wiring diagram of fig. 8. This diagram is also affixed to the hot plate.
When connection to the electricity main is made by using a socket (gas version only):
-Fit a standard plug to power cable (if supplyied). This plug should be able to bear the load indicated on the data label. Connect the wires according to the diagram in fig. 8, remembering to comply with the following instructions:
Letter L (live) = brown wire; Letter N (neutral) = blue wire;
Earth symbol =
-The powering cable must be positioned so that it is never able to reach an overtemperature of 75 K in any part.
-Never use reductions, adapters or shunts for the connection since these could cause false contacts and dangerous overheating.
-The outlet must be accessible after the
When the appliance is connected straight to the electricity main:
-Install an omnipolar cutout between the appliance itself and the main. This
-Remember that the earth wire must not be cutout by the switch.
-Alternatively, the electrical connection may also be protected by a high sensitivity differential switch.
Installers are strongly advised to connect the yellow- green earthing wire to an efficient earthing system.
The manufacturer cannot be responsible for the missing earthing of the appliance.
WARNINGS:
All our appliances are designed and manufactured in compliance with European standards EN 60
The appliance complies with the provisions of the following EEC Directives:
- CEE 2004/108/CE regarding to electromagnetic compatibility.
- CEE 2006/95 regarding electrical safety.
FIG. 8
7