Smeg PGFA95F manual Electrical connection

Page 11

Instructions for the installer

L.P.G. Can be connected to the inlet fitting directly. The pressure must be checked to ensure it is operating at 2.75kPa. A separate test point fitting must be installed between the piping & the appliance for the pressure to be checked to ensure it is operating at 2.75kPa.

3.1Electrical connection

Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason.

The plug on the end of the supply cable and the wall socket must be the same type and conform to the current electrical system regulations. Check that the power line is adequately grounded.

On the power line, install an omnipolar cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

Do not use reducers, adapters or shunts.

If the power cable is replaced, the wire section on the new cable must not be less than 0.75 mm2 (3 x 0.75 cable), keeping in mind that the end to be connected to the hob must have the ground wire (yellow-green) longer by at least 20 mm. Use only H05V2V2-F cable or similar which has a maximum temperature of 90°C. Any replacement needed should be carried out by a specialised technician who should make the mains connections according to the following diagram.

L = brown N = blue

= yellow-green

The manufacturer will not be liable for any damage to persons or property caused by non-observance of the above instructions or deriving from the tampering of even a single part of the hob.

13

Image 11
Contents Contents Instructions for Safe and Proper USE IntroductionIntroduction Installation of the Appliance Instructions for the installerInstructions for the installer Figure, to avoid damage from overheating Attachment to support structure, flush-mounting modelInstructions for the installer Requirements Clearance above and around domestic appliancesRoom ventilation Discharge of combustion products GAS ConnectionElectrical connection Adaptation to Different Types of GAS Replacement of nozzles on the hobArrangement of burners on cooking hob Burner and nozzle characteristics tableLubrication of gas taps Adjustment of minimum for natural gasFinal Operations Lighting the burners Instructions for the userUSE of the Cooking HOB Diameter of containers Practical advice for using the burnersCleaning of cooking hob components Cleaning and MaintenanceCleaning stainless steel Preventive maintenance Problems and Causes