Instructions for assembly
Type |
Type |
Clips
•Drive the clips into the worktop
•Important! The horizontal drive of the clips must be flush with the worktop (avoid the risk of breaks).
•Position the hob according to the illustration on the left side (a), align it (b) and insert the clips (c).
•Screws may be used to fasten the clips.
Important!
There is a risk of breakage if the hob is canted or subjected to stress during installation!
Minimum distance to adjacent walls
Outer dimensions of the hob
Cable routing in rear wall 
Installation height
Bracket 
•Insert the hob and align it.
•From the bottom, insert the brackets with screws in the holes provided for fastening the brackets, align the brackets and screw them tight.
•Tighten the screws with a hand screw driver only; do not use a
•In the case of thin worktops make sure that the brackets are correctly positioned.
Important!
There is a risk of breakage if the hob is canted or subjected to stress during installation!
Minimum distance to adjacent walls
Outer dimensions of the hob
Cable routing in rear wall 
Installation height
31