Smeg ST1108S instruction manual User instructions

Page 13

User instructions

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E3, E4 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

Image 13

Contents Guide for Using the Dishwasher and the Washing Programs Contents User instructions Progress Setting the Washing Program and Switching on105’ Extra Programs Table for Certification BodiesCancelling the Current Program Delaying the ProgramChanging the Program To Save on ENERGY! … and Protect the Environment Water Hardness Table Adjusting the Water Softening SystemSwitch Setting models without display Removing the Dishes END of CycleTroubleshooting User instructions For Cleaning Dishwashers Contents Safety instructions Aquastop Models Water supply connection Connecting to the Water SupplyDrain Connection Electrical connectionUser instructions Using the water softening systemAdjusting the Rinse AID Dispenser Setting Using the rinse aid and detergent dispensersAdding the Rinse AID Adding the Detergent General warnings and recommendations EN 50242 Standard Loads for Certification Bodies Using the basketsLower Basket Loading the Lower BasketUpper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketCleaning the Spray Arms Cleaning the Water Intake FilterCleaning the Spray ARM, Travelling Version Prolonged Disuse Cleaning the Filter UnitTroubleshooting Minor Problems Technical Data Achtung AttenzioneLET OP Atención