Smeg ST1108S instruction manual User instructions, Using the water softening system

Page 20

User instructions

3. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

3.1Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic softening system which uses a special regenerating salt to reduce the hardness of the water.

The dishwasher is factory set for water hardness level 3SALT (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.5 Kg of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.

Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system.

When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion.

Be careful not to confuse the salt and detergent packages; adding detergent to the salt container will damage the water softening system.

24

Image 20
Contents Guide for Using the Dishwasher and the Washing Programs Contents User instructions Setting the Washing Program and Switching on Progress105’ Table for Certification Bodies Extra ProgramsChanging the Program Delaying the ProgramCancelling the Current Program To Save on ENERGY! … and Protect the Environment Adjusting the Water Softening System Water Hardness TableSwitch Setting models without display END of Cycle Removing the DishesTroubleshooting User instructions For Cleaning Dishwashers Contents Safety instructions Aquastop Models Connecting to the Water Supply Water supply connectionElectrical connection Drain ConnectionUsing the water softening system User instructionsAdding the Rinse AID Using the rinse aid and detergent dispensersAdjusting the Rinse AID Dispenser Setting Adding the Detergent General warnings and recommendations Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketCleaning the Spray ARM, Travelling Version Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Filter Unit Prolonged DisuseTroubleshooting Minor Problems Technical Data Attenzione AchtungLET OP Atención