Smeg ST1108S instruction manual Setting the Washing Program and Switching on, Progress

User instructions

SETTING THE WASHING PROGRAM AND SWITCHING ON

To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according to dish type and degree of soiling.

After using the table to identify the most appropriate washing program:

•press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate;

•keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illuminates;

•close the door; after about 2" the program will start. While it is in progress, the relative LIGHT will flash (indicating that the program is being executed).

		PROGRAMME,		LOAD CROCKERY	PROGRAM	DURATION		CONSUMPTION
	NUMBER & SYMBOL			AND CUTLERY	PROGRESS	MINUTES		WATER		POWER
						(2)		LITRES (1)		KWh (2)
1				Pans and dishes for	Cold rinse	45'		9		0,8
			RINSE		Rinse at 68°C
				rinsing and drying
					Dry
					Cold prewash
2				Dishes	Wash at 45°C	59'		12		0,90
			DELICATE		Cold rinse
				with normal dirt
					Rinse at 68°C
					Dry
					Cold prewash
				Normally soiled	Wash at 50°C
3					Wash at 65°C
			AUTO 60-70	dishes, including		(**)		(**)		(**)
					Cold rinse
				dried-on residue
					Rinse at 68°C
					Dry
					Cold prewash
4				Dishes	Wash at 50°C	85'	16		1,10
			BIO		Cold rinse
				with normal dirt
					Rinse at 55°C

Dry

Only run the soak program with half loads.

(**)When the "AUTO 40-50" or "AUTO 60-70" program is selected, the dishwasher recognises the type of dirt and automatically adjusts the washing parameters as appropriate.

(1)Average power consumption with the softener set on level 2.

(2)The cycle duration and power consumption may vary according to the water and room temperatures, and the type and amount of dishes.