Smeg ST1108S instruction manual Water supply connection, Connecting to the Water Supply

Page 18

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units.

If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance.

To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units.

To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

For free-standing models only: if the appliance is not built-in and is therefore accessible on one side, the door hinge area must be covered for safety reasons (injury hazard).

The covering fixtures are available as an accessory from specialist dealers or the After-Sales Service.

Some models are equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.

2.1Water supply connection

Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance.

The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY

Connect the intake hose to a cold water supply with ¾” gas thread, inserting the filter A supplied with the dishwasher.

Take care to screw the hose firmly into place with your hands and then complete by tightening about ¼ of a turn with pliers. In dishwashers equipped with the ACQUASTOP device, the filters is already fitted inside the threaded ring.

22

Image 18
Contents Guide for Using the Dishwasher and the Washing Programs Contents User instructions Setting the Washing Program and Switching on Progress105’ Table for Certification Bodies Extra ProgramsDelaying the Program Cancelling the Current ProgramChanging the Program To Save on ENERGY! … and Protect the Environment Adjusting the Water Softening System Water Hardness TableSwitch Setting models without display END of Cycle Removing the DishesTroubleshooting User instructions For Cleaning Dishwashers Contents Safety instructions Aquastop Models Connecting to the Water Supply Water supply connectionElectrical connection Drain ConnectionUsing the water softening system User instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser SettingAdding the Rinse AID Adding the Detergent General warnings and recommendations Lower Basket Using the basketsEN 50242 Standard Loads for Certification Bodies Loading the Lower BasketCutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketCleaning the Water Intake Filter Cleaning the Spray ArmsCleaning the Spray ARM, Travelling Version Cleaning the Filter Unit Prolonged DisuseTroubleshooting Minor Problems Technical Data LET OP AttenzioneAchtung Atención