Instructions for the installer
2.2Fixing the flush-top model to the structure.
Create an opening with the dimensions shown in the figure in the work surface, observing a minimum distance of 50 mm from the rear edge.
The lower part of the protective cover must be fully accessible when the appliance is installed. This appliance can be installed next to walls that are higher than the
1)
the work surface, as long as the distance "X" is kept, as shown in the figure, to avoid damage from overheating. Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf that may be installed directly above them.
This type of appliance requires the worktop, the dimensions of which are shown shown in figure 2, to be milled to a depth of 2.5 mm. Before positioning the hob, position the adhesive sponge material “E” supplied over the milled surface (fig. 3). Having done this, place the hob on the milled surface and using the screws and
fixing brackets “C” or “D” (depending on | the |
depth of the worktop) secure the hob to the | 2) |
support structure, ensuring, ensuring it is level. The brackets “C” secure the hob to a structure having a depth of 20 to 30 mm. The brackets “D” on the other hand, are for use with worktops having a depth of 30 to 50 mm.
3)
Apply a layer of “waterproof primer” to the milled surface.
8