Smeg EL05 User instructions Operating instructions, Using the water softening system

Page 11

User instructions

4. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

4.1Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic softening system which uses a special regenerating salt to reduce the hardness of the water.

The dishwasher is factory set for water hardness level 3SALT (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.

Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system.

When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion.

Be careful not to confuse the salt and detergent packages; adding detergent to the salt container will damage the water softening system.

34

Image 11
Contents Dishwasher Contents Safety and operating instructions Safety instructionsAquastop Models Water supply connection Installation instructions Installation and hook-upConnecting to the Water Supply Drain Connection Installation instructionsElectrical connection Front panel User instructions Description of the controlsTable of Programs Setting the Washing ProgramUser instructions Table for Certification Bodies Half Load Wash SettingWashing programs Removing the Dishes Cancelling the Current ProgramChanging the Program END of CycleUser instructions Operating instructions Using the water softening systemWater Hardness Table Setting Adjusting the Water Softening SystemAdding the Rinse AID Using the rinse aid and detergent dispensersAdjusting the Rinse AID Dispenser Setting Adding the Detergent General warnings and recommendations Loading the Lower Basket Using the basketsLower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketCleaning the Orbital Version Spray ARM User instructions Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray ArmsProlonged Disuse Cleaning the Filter UnitTroubleshooting Minor Problems Technical Data Page