Smeg DW1410 instruction manual Troubleshooting, Dishwasher fails to heat the water

Page 28

User instructions

6. Troubleshooting

The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings:

E1

E3

E4

E5

E6

FAULTDESCRIPTION

The dishwasher’s anti-flooding system has been activated (only for models equipped with the "TOTAL ACQUASTOP” device).

This alarm is triggered in the event of a water leak in the dishwasher. In such circumstances the technical service centre must be called.

The dishwasher fails to heat the water.

Repeat the wash program. If the problem persists, contact the customer technical service centre.

The temperature monitoring system has failed. Switch the dishwasher off, switch it back on and restart the washing program.

If the alarm recurs, call the After Sales Service.

The dishwasher fails to draw water.

Ensure the plumbing connections are in order and that the water supply tap is open.

The dishwasher fails to drain.

Check that the drain hose is not kinked, the siphon is not obstructed and the filters are not clogged.

Light off

Light on

Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•In case of E1, E3 and E4, the washing program must be set again to continue.

•In case of E5 and E6, simply open and close the door to continue (once the cause of the fault has been illuminated).

57

Page 27 Page 29
Image 28
Page 27 Page 29
Contents
Dishwasher Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Connecting to the Water Supply Installation and hook-upWater supply connection Electrical connection Drain ConnectionDescription of the controls Upper panelSetting the Washing Program and Switching on Washing programs Table for Certification BodiesDelayed Start Cancelling the Current ProgramChanging the Program END of Cycle Removing the DishesUsing the water softening system Operating instructionsAdjusting the Water Softening System Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Grease and starch at temperatures above 60C General warnings and recommendations User instructions Lower Basket Using the basketsLoading the Lower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketCleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Cleaning the Spray ARM, Travelling Version Cleaning the Filter UnitGeneral Warnings and Recommendations for Correct Maintenance If the dishes are not being cleaned properly, check that Troubleshooting Dishwasher fails to heat the waterTechnical Data