Instructions for the installer
16. FINAL OPERATIONS
After replacing the nozzles, reposition the
Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with the nozzles.
16.1 Regulation of the hob burner minimum level for natural gas
Light the burner and turn it to the minimum position 
. Extract the gas tap knob and turn the adjustment screw at the side of the tap rod until the correct minimum flame is achieved.
Replace the knob and check burner flame stability: (rapidly turning the knob from maximum to minimum position, the flame should not go out). Repeat the operation on all the gas taps.
16.2 Regulation of the hob burner minimum level for LPG
In order to adjust the minimum with LPG, the screw at the side of the tap rod must be turned clockwise all the way.
The bypass diameters for each individual burner are shown in paragraph “15.2 Burner and nozzle characteristics table". Once the regulation has been completed, restore the seal on the
16.3 Mounting the rear top skirtboard
To fit the upstand, proceed as follows, step by step.
1.Place the upstand on the back of the cooker as shown in the picture.
2.Fix it to the hob using the holes "A" (see picture) and the three screws (supplied).
16.4Wall fixing
•Stretch out the chain attached to the cooker horizontally so that the other end touches the wall.
•Mark the wall in the position where the hole is to be drilled.
•Drill the hole, insert a wall plug and attach the chain.
•Move the cooker up against the wall.
25