Technical notes, How to use this program

Instructions for the User

4.11.1 How to use this program

Use the knob to select the "easy" program (P10 *).

The display shows "- - - - " to indicate that there are no cooking parameters present.

Press START or keep it pressed to increase the preheating temperature (from 30° to 250°).

Press STOP to move on to displaying the next parameter. The display shows H2O.

Press START to increase the number of seconds of water infeed per minute (from 0 to 5 where 0 means conventional fan-mode cooking without the aid of humidification).

Press STOP to increase the number of minutes of cooking (N.B. if a cooking time of 99 minutes is set, the cooking time will be infinite, meaning that cooking can only be stopped in manual mode, by ending the program).

Release STOP and preheating will start automatically after 5 seconds. N.B. – When the cooking process is over, to repeat the same program do not turn the knob and press START again.

4.12 Possible error messages on the display

The display is able to show two different types of error:

Err1 = probe failure.

Err2 = low voltage: less than 160 volts.

4.13 Technical notes

If the power supply to the appliance fails at any time, always return the knob to the 0 setting before running any programs.