Summit FF-7, FF-6 instruction manual Operation control, How To Adjust The Thermostat

Page 6
Operation control

Operation control

How To Adjust The Thermostat

The refrigerator is controlled with a thermostat knob located inside unit, towards the right-hand corner. Turn the knob clockwise from the STOP (0) position toward higher numbers for colder temperatures.

TEMPERATURE SELECTION

The settings of the temperature control are from 0 (off) to 7 (max). Initially adjust the temperature control setting to 4 (norm), then adjust the thermostat to colder or warmer (as needed).

A higher setting on the knob (towards 7) means colder temperatures in all compartments of the appliance. On the highest setting, parts of the refrigerator may become extremelycold, especially in cooler or dry weather. Use the higher thermostat setting only when required or recommended.

The coolness of the refrigerator depends on how often you open and close the door.

To turn the refrigerator off you must turn the thermostat to 0 (off).

Instructions for Use

6

Image 6
Contents All Variations of the FF-7 All Variations of the SCR-600L/SCR-600BL ALL-REFRIGERATORFELIX STORCH, INC SUMMIT APPLIANCE DIVISION Maintenance and Cleaning Table of ContentsPlacing and Installation Write the model and serial numbers here Model# Serial #Tips for Energy Savings Before Putting Into UsEWe Care for the Environment Instructions for UseDisposing of the Worn Out Appliance PLACING AND INSTALLATION Connection to Power Supply“DO NOT USE AN EXTENSION CORD.” How To Adjust The Thermostat Operation controlTo turn the refrigerator off you must turn the thermostat to 0 off Storing Fresh Foods automatic DefrostingCleaning the Appliance Switch Off the Appliance When Not in UseDoor swing reversal Problem #1 Adjusting the Level legsTrouble-Shooting Guide Appliance Fails to Operate After Connecting to the Power SupplyNoise SolutionProblem #3 Ice Formation on the Inner Rear WallBefore Calling for Service Check the plug and fuse Test the outlet with a lampSpecifications are Subject to Change Without Noti1ce