Summit FF-6, FF-7 instruction manual Door swing reversal

Page 9
Door swing reversal

Door swing reversal

(Stainless steel models with towel bar handles do not have reversible doors.)

If you find the direction of opening the door on your appliance inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory

1.Remove the top hinge cover and hinge (on models with a tabletop, remove the bottom hinge instead).

2.Next remove the door and remove the bottom hinge.

3.Then remove the kick plate, slide it over to the opposite side and secure in place.

4.Place the lower hinge on the opposite side of the unit and reattach the door,

5.Reattach the top hinge on the opposite side of the unit, it should be aligned with the bottom hinge

6.Remove handle by unscrewing, place on the opposite side and secure in place.

7.Insert plugs into the holes where the door was initially attached.

8.Check to make sure the door seals properly.

(If it does not, use a hair dryer set on medium to expand the gasket.)

1.

Upper hinge cover

4. Kick plate

2.

Upper hinge

5. Handle

3.

Lower hinge

6 Hole Plugs

9

Image 9
Contents All Variations of the FF-7 All Variations of the SCR-600L/SCR-600BL ALL-REFRIGERATORFELIX STORCH, INC SUMMIT APPLIANCE DIVISION Placing and Installation Table of ContentsMaintenance and Cleaning Write the model and serial numbers here Model# Serial #We Care for the Environment Before Putting Into UsETips for Energy Savings Instructions for UseDisposing of the Worn Out Appliance PLACING AND INSTALLATION Connection to Power Supply“DO NOT USE AN EXTENSION CORD.” How To Adjust The Thermostat Operation controlTo turn the refrigerator off you must turn the thermostat to 0 off automatic Defrosting Storing Fresh FoodsSwitch Off the Appliance When Not in Use Cleaning the ApplianceDoor swing reversal Trouble-Shooting Guide Adjusting the Level legsProblem #1 Appliance Fails to Operate After Connecting to the Power SupplyProblem #3 SolutionNoise Ice Formation on the Inner Rear WallBefore Calling for Service Check the plug and fuse Test the outlet with a lampSpecifications are Subject to Change Without Noti1ce