Convection Steam Oven Specifications | 5 |
Convection Steam Oven
The convection steam oven can be installed with or without side trim in a standard or flush inset application. The installation opening must have a flat, level base to support the oven. A minimum base support of 100 lbs
(45 kg) is required. The electrical supply for the oven must be located in an adjacent cabinet.
STANDARD INSTALLATION
For standard installations, the convection steam oven is installed by inserting into cabinetry from the front. The oven has face trim on the top and both sides that will overlap stiles and rails. Refer to the chart below for trim overlaps.
Oven Trim Overlap
Top Overlap | 3/16" | (5) | |
Bottom Overlap | 0" | (0) | |
Side Overlap (without trim) | 5/8" | (16) | |
Side Overlap (with trim) | 313/16" | (97) | |
|
|
|
|
FLUSH INSET INSTALLATION
For flush inset installations, a minimum 1/8" (3) reveal is required on all four sides. The inside edges of the rough opening must be finished, as they will be exposed when the oven door is open. These edges should be stained instead of having a laminated surface, to avoid damage from high temperatures and steam.
wolfappliance.com/specs
COMBINATION INSTALLATIONS
The Wolf convection steam oven with trim is designed and agency approved for installation with Wolf cooktops,
If it is being installed above or below an E series oven in a flush inset application, a 1/4" (6) reveal is required.
For typical combination installations, refer to the illustra- tions on pages