Ice Machine Installation Reverse Door Swing

Ice Machine Installation	10

Reverse Door Swing

The hinged side of the door may be reversed to the other side if needed.

The ice machine is shipped with the door hinged at the right. The door and hinges are designed for placing the hinges on either the right or the left side of the unit.

Moving the hinges to the left in the pre-drilled holes, allows the door to pivot from the left side.

IMPORTANT NOTE: The plastic molding which covers the top area of the door, packaged with the ice machine, is required for this procedure.

1) To begin, remove the four screws that secure the door

hinges to the ice machine. Refer to the illustration

below. Remove the door. Remove the shim located

2)Remove the hinges from the door by removing the four screws (two per hinge) that secure the hinges to the door. Refer to the illustration below.

3)Remove the right-hand upper trim (shaded area) from the door by removing the two screws that secure it to the door. Refer to the illustration below. Replace it with the left-hand upper trim.

4)Transfer the hinges to the left side of the door and reinstall. The upper hinge will now be in the lower hinge position and the lower hinge will now be in the upper hinge position. Refer to the illustration below.

between the cabinet and bottom hinge, this shim will

transfer to the left side bottom hinge.

HINGE

SCREWS

UPPER	HINGE
TRIM (RH)
	HINGE

HINGE	UPPER
	TRIM (LH)
HINGE

Remove door.

Remove hinges and trim.

Transfer hinges.