Ice Machine Specifications | 7 |
Plumbing Requirements
DRAIN CONNECTION
Models
Models
Gravity drain models are supplied with a drain hose for gravity draining. A pump model must be used if a gravity drain is not possible. Both drain methods require routing to an open site drain. Do not connect directly to a drain line as bacteria from the drain line may contaminate the ice machine. Locate the drain in an adjacent cabinet. Refer to the illustrations below. For installations that will not allow the drain to be placed in an adjacent cabinet, the drain must be located within 1/2" (13) of the back wall.
Improper drainage can lead to water flowing back into ice machine and poor performance.
subzero.com/specs
•The ice machine drain connection is approximately 5" (127) from the floor.
•For the gravity drain, all horizontal runs of drain lines must have a 1/4" (6) per 12" (305) fall.
•Drain pump models have a maximum rise of 12' (4 m) and a maximum run of 100' (31 m).
•Drain pump models will likely require an air gap between the unit and the drain receptacle.
•The floor drain must be large enough to accommodate drainage from all drain lines.
•The drain pump discharge line must terminate at an open site drain.
•If there is not adequate room behind the ice machine for the drain or waste water receptacle, the drain can be located below the floor.
WATER FILTER
| WATER |
SUPPLY | |
VALVE |
|
| DRAIN |
| TUBE |
VALVE |
AIR GAP
DRAIN TUBE
WATER
SUPPLY
The water filter provided with the ice machine is designed to inhibit scale formation, filter sediment, and remove chlorine odor and taste. The life expectancy of the water filter is approximately six months during normal usage. The ice machine control board will monitor water usage and indicate when replacement is required.
Replacement water filters are available through your authorized
Gravity drain models. | Drain pump models. |