Side Panel Installation, Install Kickplate

Ice Machine Installation

Panel Installation

Exercise caution when drilling holes for mounting hardware. This is especially critical with inset panels.

If the reveal on the hinge side of the door panel is less than 1/4", and the panel has a square corner, severe finger pinching or damage to the unit may occur.

SIDE PANEL INSTALLATION

With the ice machine, you must securely fasten side panels to adjacent cabinets and floor. Brackets and screws are provided for mounting the unit to adjoining cabinets and side panels.

Side panels should be fastened to the floor and walls using L-shaped brackets (not included). To help move the unit into place, rout out an area in the floor so the bracket will sit flush with the floor.

subzero.com/specs

Installation

INSTALL KICKPLATE

Once the ice machine is in position, install the kickplate using the screws provided. The kickplate must be removed for servicing. The floor cannot interfere with removal. Do not cover the vents of the kickplate to allow proper airflow. The door panel may hang in front of the vents, but a decorative kickplate must not cover the vents.

If you choose, the kickplate may be painted another color. Follow these steps: Rough up the surface to be painted with fine grit sandpaper. Wipe with alcohol to ensure that the surface is clean and dry. Use an appliance or industrial grade, oil base, high gloss enamel paint.