Atlas Sound CP700 Commercial Power Amplifier Front Panel Description, Power Switch

Page 4

CP700 COMMERCIAL

POWER AMPLIFIER

FRONT PANEL DESCRIPTION

OWNER'S MANUAL

2

PROTECT

 

PROTECT

 

 

LIMIT

 

LIMIT

CP700

 

CH-1

CH-2

SIGNAL

POWER

SIGNAL

 

 

 

 

 

 

Commercial Power Amplifier

 

1

3

4

1.Power Switch

This rocker switch supplies power to the CP700 amplifi er. will illuminate when the CP700 is switched on.

Figure 1

A red LED located above the power switch

2.Protect LED Indicators

The CP700 features several types of protection circuitry to prevent damage during turn-on or fault conditions. If any of these LEDs illuminate, one of the various protection features is safeguarding the amplifi er. The output relays will disconnect the speaker loads when the protection circuitry detects a fault condition.

Loudspeaker Protection - When power is fi rst applied, the speaker protection relay is open, preventing transients from reaching the loudspeakers. After the internal power supplies have stabilized, the relay will close, connecting the amplifi er output to the load. The yellow Protect LEDs will illuminate during this power up process.

Thermal Protection - The CP700 protection circuitry monitors itself for excessive internal operating temperatures. In the event of this circuitry detecting abnormal thermal conditions (blocked cooling fan and high ambient temperatures), the speaker relay will disconnect the speaker load from the amplifi er. Once the internal operating temperature drops back to a safe level, the relay will close, reconnecting the speaker load to the amplifi er.

Short Circuit Protection - The yellow Protect LEDs will illuminate should the amplifi er detect a short circuit on the attached speaker load or if the load impedance is too low. When this condition is detected, the internal speaker relays will open up, disconnecting the load from the amplifi er. The protection circuitry will stay activated until the fault is cleared.

Note: Once the specifi c fault has been corrected, the power may have to be cycled to reset the protection circuitry.

3.Signal "Status" LED Indicator

The green "Status" LEDs will illuminate once the input signal has reached -26dBv or higher.

Specifications are subject to change without notice

AtlasSound.com

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •

TELEPHONE: (800) 876-3333

FAX: (800) 765-3435

©2005 ATLAS SOUND LP

Printed in U.S.A.

ATS002102 RevC 9/05

PP

4

Image 4
Contents CP700 Commercial Power Amplifier CP700 Commercial Power AmplifierCP700 Commercial Power Amplifier Table of Contents Safety InstructionsHearing Damage Shock HazardFeatures CP700 Commercial Power Amplifier IntroductionApplications CP700 Commercial Power Amplifier Front Panel Description Power SwitchProtect LED Indicators Signal Status LED IndicatorRear Panel Description Stereo/Parallel/Bridge Switch 10. CH1/CH2, Low Impedance Speaker Outputs11. CH1/CH2, 25/70.7/100V Speaker Outputs Calculating Constant Voltage LoadsCP700 Commercial Power Amplifier Input Wiring Balanced InputsUnbalanced Input Low Impedance Direct Coupled Output Stereo CP700 Commercial Power Amplifier Speaker Output WiringLow Impedance Direct Coupled Output Parallel Mono Bridge Mono Configuration Direct Coupled 25V, 70.7V, and 100V Transformer Output Wiring25V 70.7V100V CH-2 To 200V speaker load CP700 Commercial Power Amplifier Specifications Direct Power OUT Protection CircuitsLimited Warranty