Pull knob and trim ring straight out. Remember how the spring goes.
Terminal
| _b; | \ |
|
| / |
| |
|
| / | I. |
\ | I |
| i .:”2’ |
crfI!!!e\
Receptacle
To remove surface unit, lift and pull straight out.
Accessory canning kit (Part No. 242905)
The large diameter of most
bined with high heat settqs for long periods of time can shorten the life of regular surface units and cause damage to the cooktop.
If you plarl to use the cooktop for canning. we recommend the
installation of a Cannillg Kit Order the kit from your Whirlpool Dealer or
SEE THE “COOKING GUIDE” FOR IMPORTANT CANNING INFORMATION.
Cleaning and caring for your range
Your range IS designed to be easy to clean You will usually wipe off
spills and spatters when they happen. but you will sometimes want to clean under and behlnd the control knobs and surface units. This sectlon will tell you how to remove those. and what to use when clean,ng
Removing and replacing surface unit control knobs:
1Be sxe the control knobs are set to “OFF ”
2Pull the black krlobs straight off.
13 If the control has a chrome trim ring. pull it stralyht off
4Wash the knobs (and trim rings) In warm. sudsy water
5Replace the trim rings first If the control spring was removed, put
it back exactly as shown on the left.. .small end first.
6 Hold the black knob so It points to “OFF“ Push it straight back on
Removing and Replacing Oven Control Knobs:
1Be sure the knobs are set to “OFF.”
2 Pull each knob straight off.
3 Wash the knobs In warm. sudsy klater
3 The knobs are not Interchangeable Make sure you put the adjust-
able Oven Temperature Control Knob on the right place. ,~nd the nonadjustable Oven Selector Knob on the other
Removing surface units and reflector bowls:
1 F!rst be sure the> Surface Unit Controls are all .‘OFF“ and that the surface units are cool
2Lift
plug In (receptacle) Pull the unit straight away from thtj
not wmh surface units. they will burn themselves clea~l durlrly normal
UW
.3. Lift out the reflector bowls.