Hold surface unit level when replacing.
Replacinu reflector bowls and surface units:
Be sure the surface unit controls are on “OFF.”
Put the reflector bowls back into their places. Make sure you can see
the
Hold the surface unit level with the prongs (terminals) pointing at the
With the prongs started in the
Make sure the
Foil should be flat on the bottom so should the feet on the element.
Prop up the top with support rod.
Easier cleaning with aluminum foil:
Oven cleaning can be a chore when spillovers bake onto the
bottom of the oven. Use aluminum foil so you can just throw it away with
the spillovers. You can use the
found in most grocery stores. Or you can order an aluminum foil kit (Part
Number 241430) from wour Whirlpool Dealer.
1 When cutting the foil, make sure it is long enough to cover the bottom wtth enough left over to start up both sides.
2.Make sure the bake element is cool. Lift it far enough to raise its feet
from the bottom of the oven (You may have to remove the
oven | rack. | ) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Slide | the |
| foil sheet |
| under | the bake | element. | Make | sure | it | 1s centered | |||||||
and long | enough | to start up the sides |
|
|
|
|
|
|
| |||||||||
When | you | put | the | bake | element |
| back | down, | make | sure | all | the | feet | |||||
rest | solidly | on | the |
| foil | and | that | the foil | is smoothed | out | across | the | ||||||
bottom | of | the | oven | If | the | feet | on | the element | are | not | solidly | on | the | |||||
foil. | the | oven | may |
| not | bake | properly |
|
|
|
|
|
|
|
Cleaning under the cooktop:
To clean the area under the cooktop. lift the front of the cooktop at the center. Raise the
in the notch in the cooktop.) Use warmsoapy water and a sponge or cloth.
Scouring powders or any other abrasive cleaner may harm porcelain- enamel finishes and can scratch chrome.
Be careful not to raise the cooktop so high that it touches the control console. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain ftnish. or damage side panels and surface unrts.
Removing the oven door:
Removing the oven door may make it easier to clean the oven. To
Pull straight with the remove the door, ftrst open it to the first stop (about 4 inches or 10 cm). angle of
angle it is in.
With the door off, you will notice how the ends of the htnges slide Into slots at the bottom corners of the door. To put the door back on, fit both bottom corners of the door over the ends of the hinges. Push the door down evenly, so neither corner gets ahead of the other. When it reaches the bottom, you can close the door. A safety latch will hold the door open until it is on correctly.
Push down evenly.‘
10