II I’
To remove surface unit, lift and pull straight out.
Hold surface unit level when replacing.
Prop up the top with support rod.
Pull to stop. Lift: pull again.
Removing surface units and reflector bowls:
1.First, be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.
2.Lift each surface unit about an inch (2.5 cm) at the edge away from the
USe.
3. Lift out the reflector bowls.
Replacinn reflector bowls and surface units:
1.Be s&e the surface unit controls are on “OFF”
Put the reflector bowls back into their places. Make sure you can see the
Hold the surface unit level with the prongs (terminals) pointing at the
With the prongs started in the
Make sure the
Cleaning under the cooktop:
To clean the area under the cooktop, lift the front of the cooktop at the center. Raise the
Scouring powders or any other abrasive’cleaner may
Be careful not to raise the cooktop so high that it touches the control console. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain finish, or damage side panels and surface units.
Removing the storage drawer (use care when handling the drawer): The drawer below your oven is meant to store pots and pans.
Never keep anything in there that will burn or melt.
You may want to remove the drawer for cleaning under the range. Pull it straight out until it stops. Lift the front and pull some more to get it over the stop. Now slide it out until it stops again. Lift the drawer away from the range until it slips out of the guides.
To put it back. fit the side rails at the back of the drawer into both guides on the range. Push it closed while lifting the front to get past the stops.
13