Aiwa CX-NA22 manual Setting the Timer, Timer Recording

Page 17

SETTING THE TIMER

4

1

1,2

.3

‘

2,4

5

u 6

The unit can be turned on at a specified time every day ‘with the built-in timer.

Preparation

Make sure the clock is set correctly,

Use the remote control.

1 Press the TIMER button while pressing the SHIFT button once to display 0, and press the 11 SET button within 4 seconds.

O is displayed, and the hour flashes.

o

m’

If you press the 11 SET button after 4 seconds, another operation may start.

2 Designate the hour of the timer-on time by

pressing the < DOWN or _ UP button, and press the 11 SET button. Repeat to designate the minute of the timer-on time.

To listen to the ;adio, tune in to a station.

6Press the POWER button to turn the unit off after adjusting the volume and tone.

O remains on the display after the power is turned off (timer standby mode).

When the timer-on time is reached, the unit turns on and begins play with the selected source.

The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more,

To check the specified time and source

Press the TIMER button while pressing the SHIFT button. The timer-on time, the selected source name and the duration for ❑ the timer-activated period are displayed for 4 seconds.

To cancel timer standby mode temporarily

Press the TIMER button repeatedly while pressing the SHIFT button so that O disappears on the display.

To restore the timer standby mode, press again to display ~.

Using the unit while the tinner is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

After you designate the timer-on time, one of the source name flashes on the display for 4 seconds.

3 Within 4 seconds, press the FUNCTION button repeatedly to select a source.

The selected source name flashes for 4 seconds.

●If this step is not completed within 4 seconds, repeat from step 1.

●If the TUNER button is pressed, the band cannot be selected in this step.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press the TIMER button repeatedly while pressing the SHIFT button so that @ flashes on the display, and press the II SET button within 4 seconds. Flepeat the steps shown above from step 2 and insert the tape to be recorded into deck 2 after step 5.

m

●Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

ENGUS/-/ 16

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Call toll free I-800-BUY=AIWA CX-NA22 SX-NA22 PrecautionsTable of Contents Connect the right and left speakers to the main Unit ConnectionsConnect the supplied AM antenna to the AM Loop terminal.Q Connect the AC cord to an AC outletRemote Controil Shift Preset FunctionTo stand the AM antenna on a surface \ To connect other optional equipment+Before Operation VolumeSuper T-BASS SYST,EM To turn the unit onTo select with the remote control Manual TuningGraphic Equalizer Press the 4+ Down or UP button to select a stationPreset Number Tuning PRESETTING’STATIONSSelecting a preset number on the main unit To clear a preset stationPress the button to start play Basic OperationsOpen Close Loading DiscsPlaying Discs Press one of the Disc Direct Play buttons to select a disc Programmed PlayRandom /REPEAT Play Basic Recording To stop dubbing Dubbing a Tape ManuallyPress the Sync DUB button to start recording Press the REC button to start recording on the first side Insert the tape into deckTo stop recording Time on cassette tapes and editing timeRepeat for the rest of the tracks for side a Programmed Edit RecordingTo check the order of the programmed track numbers To change the program of each sideSetting the Clock Timer Recording Setting the TimerListening to External Sources Connecting Optional EquipmentVIDEO/AUX Jacks CD Digital OUT Optical JackTroubleshooting Guide Care and MaintenanceGeneral Tuner SectionCopyright SpecificationsXhxd Page Anotacion del propietario PrecaucionesInstalacion Eneraia electricaIndice Conecte la antena de AM suministrada al terminal ConexionesAM Loop Conecte el cable de alimentacion de CA a una toma de CAPara conectar otro equipo optional + pagina Control ReniiotoCuancfo reemplazar Ias pilas Para utiiizar el boton Shift del control remotoAntes IDE LA Operacion Control DE VolumenSistema Super T-BASS IIIPulse el boton 4+ Down o FF UP para seleccionar una emisora Ecualizador Grafico Sintonizacion ManualSintonizacion Mediante Numero DE Preajuste Preajijste DE EmisorasRepita h pasos 1 y Selecci6n de un numero de preajuste en la unidad principalPulse el boton ~ para iniciar la reproduction Introduction DE Discos BasicasReiwoduccion DE Discos Hacia arribaShift Reproduction ProgramadaReproduction Aleatorw Repetition DE Reproduction Para grabar de una fuente de sonido conectada, pulse el GRABAC1ON BasicaPulse el boton REC para iniciar la grabacion Copiado DE Toda LA Cinta Copiado Manual DE UNA CintaPulse el boton TAPE/DECK 1/2 para seleccionar la piatina Pulse el boton Sync DUB para iniciar laPara detener la grabacion Inserte la cinta en la platinaPara borrar el programa de edition Tiempo de Ias cinitas de casete y tiempo de editionPara cambiar el programa de cada cara Grabacion CON Edicion ProgramadaPara detener la cwabacion Ajuste DEL Teimporizador Para Dormir Puesta EN Hora DEL RelojPulse el boton Sleep mientras pulsa el boton ShiftPrepare la fuente de sonido Ajuste DEL TemporizadorGrabacion CON Temporizador Opcional Sonido Externas Conexion DE UN EquipoTomas VIDEO/AUX Toma CD Digital OUT OpticalCuidados Y Mantenimiento Guia Para LA Solucionde ProblemasGeneralidades Seccion DEL SintonizadorDerechos DE Autor EspecificacionesPage Cordon d’alimentation sectwr InstallationRelev6 du proprietaire Table DES Matieres Avant de brancher Ie cordon secteur Contr61er la chatne et Ies accessoiresConnexions Antenne AM TelecommandeSysteme Super T-BASS VolumeAvant L’UTILISATION Accord Manuel Egaliseur GraphiquePour changer I’intervalle d’accorcl AM AutomatiqueAccord SUR UNE Station Memoriseie Memorisation DE StationsRepeter Ies etapes 1 et ClearAppuyer sur la touche E pour demarrer la lecture Operations DE BaseOPEN/CLOSE Mise EN Place DE DisquesLecture DE Disques Lecture ALEATOIRE/REPETEE Lecture ProgrammedInserer la cassette a enregistrer clans la platine Enregistrement DE BaseAppuyer sur la touche O REC pour demarrer ’enregistrement Pour enregistrer a partir d’une source connectee, appuyerPour arr6ter la duplication Appuyer sur la touche REC pour demarrer ’enregistrementDe la cassette Pour arr&er la duplicationInserer la cassette clans la platine Enregistrement Avec Montage ET Calcul DU TempsRepeter I’etape 5 pour Ie reste des plages de la face a Enregistrement Avec Montage ProgrammeReglage DE LA Minuterie ’ARRET REGLAGEDEL’HORLOGEReglage DE LA Minuterie Enregistrement Commande PAR LA MinuterieEcoute DE Sources Externes Connexion D’UN Appareil OptionnelPrises VIDEO/AUX Prise CD Digital OUT OpticalGeneralities Soins ET EntretienPartie Tuner Partie MagnetocassetteDroits D’AUTEUR SpeakersPage Page Page Nomenclature Indice DE LAS Partes

CX-NA22 specifications

The Aiwa CX-NA22 is a versatile mini stereo system that blends classic design with contemporary functionality, making it an appealing choice for music enthusiasts. This compact system is engineered to deliver impressive audio output while remaining user-friendly and aesthetically pleasing.

One of the standout features of the Aiwa CX-NA22 is its powerful amplifier, which ensures clear and dynamic sound reproduction. The system includes dual speakers, each capable of producing rich bass and crisp treble, providing a well-balanced audio experience suitable for various genres of music. With a total output power of 40 watts, the CX-NA22 is designed to fill a small to medium-sized room with quality sound.

The CX-NA22 also excels in its connectivity options. It features a built-in CD player, allowing users to enjoy their favorite albums without the need for external devices. Additionally, the system includes a USB port, enabling direct playback of music files from USB flash drives. This modern technological aspect appeals to users who prefer digital music formats, while the traditional FM/AM radio tuner provides access to a wide range of radio stations, catering to diverse listening preferences.

Another notable technological highlight of the Aiwa CX-NA22 is its Bluetooth capability. This feature allows for wireless streaming of music from smartphones or tablets, providing the convenience of playing music without the restriction of wires. The integration of Bluetooth technology makes it easy to enjoy playlists and online streaming services directly through the stereo system.

The CX-NA22 includes a user-friendly interface with an LCD display, which shows track information and radio station details. The system features dedicated buttons for easy navigation, ensuring that users can quickly switch between different modes and adjust settings without hassle.

With its compact design, the Aiwa CX-NA22 is perfect for those with limited space but who still crave high-quality sound. Its stylish aesthetic will blend effortlessly into most home decor styles, enhancing both functionality and visual appeal. Overall, the Aiwa CX-NA22 stands out in the market of mini stereo systems, merging classic audio performance with modern technology for a well-rounded listening experience.
Top Page Image Contents