Aiwa CX-NA22 manual Care and Maintenance, Troubleshooting Guide, General, Tuner Section

Page 19

CARE AND MAINTENANCE

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the”cabinet

Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.

To clean the heads and tape paths

After every 10 hours of use, clean the heads and tape paths with a head cleaning cassette or cotton swab moistened with cleaning fluid or denatured alcohol. (These cleaning kits are commercially available.)

When cleaning with a cotton swab, wipe the recording/playback head (deck 2 only), erasure head (deck 2 only), capstans, and pinchrollers.

;rasure head

Cotton swab

After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the cleaned parts are completely dry before inserting the tapes.

To demagnetize the heads

The heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise. After 20 to 30 hours use, demagnetize the heads with any commercially available demagnetizer.

Care of discs

●When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.

●After playing a disc, store the disc in its case. Do not leave the disc in place~ that ar~ hot or humid.

Care of tapes

●Store tapes in their cases after use.

●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

TROUBLESHOOTING GUIDE

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

.

There is no sound.

 

●Is the AC cord connected properly?

●Is there a bad connection? (-+ page 3)

●There may be a short circuit in the speaker terminals.

-+ Disconnect the AC cord, then correct the speaker connections.

●Was an incorrect function button presse’d?

Sound is emitted from one speaker only.

●Is the other speaker disconnected?

An erroneous display or a malfunction occurs.

+Reset the unit as stated below.

TUNER SECTION

There is constant, wave-like static.

●Is the antenna connected properly? (+ page 3)

The reception contains noise Interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion?

+

Change the orientation of the antenna.

 

+

Move the unit away from other electrical appliances.

‘

CASSETTE

DECK SECTION

 

The tape does not run.

 

● Is deck 2 in pause mode? (+ page 8)

 

The sound is off-balance or not adequately high.

❑

● Is the playback head dirty? (-+ page 18)

Recording

is not possible.

●Is the erasure prevention tab on the tape broken off? (+ page

8)

●Is the recording head dirty? (+ ~age 18)

Erasure is not possible.

●Is the erasure head dirty? (+ page 18)

●Is a metal tape being used?

High frequency sound is not emitted.

●Is the recording/playback head dirty? (+ page 18)

CD PLAYER SECTION

The CD player does not play.

●Is the disc correctly inserted? (-+ page 9)

●Is the disc dirty? (+ page 18)

●Is the lens affected by condensation?

+ Wait approximately one hour and try again.

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press me POWER button to turn on the power.

2Press the POWER button to turn the power back on while pressing the 9 CLEAR button. Everything stored in memory

after purchase is canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then repeat step 2.

ENGLISH 18

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Call toll free I-800-BUY=AIWA CX-NA22 SX-NA22 PrecautionsTable of Contents Connect the AC cord to an AC outlet ConnectionsConnect the right and left speakers to the main Unit Connect the supplied AM antenna to the AM Loop terminal.Q\ To connect other optional equipment+ Shift Preset FunctionRemote Controil To stand the AM antenna on a surfaceTo turn the unit on VolumeBefore Operation Super T-BASS SYST,EMPress the 4+ Down or UP button to select a station Manual TuningTo select with the remote control Graphic EqualizerTo clear a preset station PRESETTING’STATIONSPreset Number Tuning Selecting a preset number on the main unitPress the button to start play Basic OperationsPlaying Discs Loading DiscsOpen Close Random /REPEAT Play Programmed PlayPress one of the Disc Direct Play buttons to select a disc Basic Recording Press the Sync DUB button to start recording Dubbing a Tape ManuallyTo stop dubbing Time on cassette tapes and editing time Insert the tape into deckPress the REC button to start recording on the first side To stop recordingTo change the program of each side Programmed Edit RecordingRepeat for the rest of the tracks for side a To check the order of the programmed track numbersSetting the Clock Timer Recording Setting the TimerCD Digital OUT Optical Jack Connecting Optional EquipmentListening to External Sources VIDEO/AUX JacksTuner Section Care and MaintenanceTroubleshooting Guide GeneralXhxd SpecificationsCopyright Page Eneraia electrica PrecaucionesAnotacion del propietario InstalacionIndice Conecte el cable de alimentacion de CA a una toma de CA ConexionesConecte la antena de AM suministrada al terminal AM LoopPara utiiizar el boton Shift del control remoto Control ReniiotoPara conectar otro equipo optional + pagina Cuancfo reemplazar Ias pilasIII Control DE VolumenAntes IDE LA Operacion Sistema Super T-BASSPulse el boton 4+ Down o FF UP para seleccionar una emisora Ecualizador Grafico Sintonizacion ManualSelecci6n de un numero de preajuste en la unidad principal Preajijste DE EmisorasSintonizacion Mediante Numero DE Preajuste Repita h pasos 1 yPulse el boton ~ para iniciar la reproduction Hacia arriba BasicasIntroduction DE Discos Reiwoduccion DE DiscosReproduction Aleatorw Repetition DE Reproduction Reproduction ProgramadaShift Pulse el boton REC para iniciar la grabacion GRABAC1ON BasicaPara grabar de una fuente de sonido conectada, pulse el Pulse el boton Sync DUB para iniciar la Copiado Manual DE UNA CintaCopiado DE Toda LA Cinta Pulse el boton TAPE/DECK 1/2 para seleccionar la piatinaTiempo de Ias cinitas de casete y tiempo de edition Inserte la cinta en la platinaPara detener la grabacion Para borrar el programa de editionPara detener la cwabacion Grabacion CON Edicion ProgramadaPara cambiar el programa de cada cara Shift Puesta EN Hora DEL RelojAjuste DEL Teimporizador Para Dormir Pulse el boton Sleep mientras pulsa el botonGrabacion CON Temporizador Ajuste DEL TemporizadorPrepare la fuente de sonido Toma CD Digital OUT Optical Conexion DE UN EquipoOpcional Sonido Externas Tomas VIDEO/AUXSeccion DEL Sintonizador Guia Para LA Solucionde ProblemasCuidados Y Mantenimiento GeneralidadesDerechos DE Autor EspecificacionesPage Relev6 du proprietaire InstallationCordon d’alimentation sectwr Table DES Matieres Connexions Contr61er la chatne et Ies accessoiresAvant de brancher Ie cordon secteur Antenne AM TelecommandeAvant L’UTILISATION VolumeSysteme Super T-BASS Automatique Egaliseur GraphiqueAccord Manuel Pour changer I’intervalle d’accorcl AMClear Memorisation DE StationsAccord SUR UNE Station Memoriseie Repeter Ies etapes 1 etAppuyer sur la touche E pour demarrer la lecture Operations DE BaseLecture DE Disques Mise EN Place DE DisquesOPEN/CLOSE Lecture ALEATOIRE/REPETEE Lecture ProgrammedPour enregistrer a partir d’une source connectee, appuyer Enregistrement DE BaseInserer la cassette a enregistrer clans la platine Appuyer sur la touche O REC pour demarrer ’enregistrementPour arr&er la duplication Appuyer sur la touche REC pour demarrer ’enregistrementPour arr6ter la duplication De la cassetteInserer la cassette clans la platine Enregistrement Avec Montage ET Calcul DU TempsRepeter I’etape 5 pour Ie reste des plages de la face a Enregistrement Avec Montage ProgrammeReglage DE LA Minuterie ’ARRET REGLAGEDEL’HORLOGEReglage DE LA Minuterie Enregistrement Commande PAR LA MinuteriePrise CD Digital OUT Optical Connexion D’UN Appareil OptionnelEcoute DE Sources Externes Prises VIDEO/AUXPartie Magnetocassette Soins ET EntretienGeneralities Partie TunerDroits D’AUTEUR SpeakersPage Page Page Nomenclature Indice DE LAS Partes

CX-NA22 specifications

The Aiwa CX-NA22 is a versatile mini stereo system that blends classic design with contemporary functionality, making it an appealing choice for music enthusiasts. This compact system is engineered to deliver impressive audio output while remaining user-friendly and aesthetically pleasing.

One of the standout features of the Aiwa CX-NA22 is its powerful amplifier, which ensures clear and dynamic sound reproduction. The system includes dual speakers, each capable of producing rich bass and crisp treble, providing a well-balanced audio experience suitable for various genres of music. With a total output power of 40 watts, the CX-NA22 is designed to fill a small to medium-sized room with quality sound.

The CX-NA22 also excels in its connectivity options. It features a built-in CD player, allowing users to enjoy their favorite albums without the need for external devices. Additionally, the system includes a USB port, enabling direct playback of music files from USB flash drives. This modern technological aspect appeals to users who prefer digital music formats, while the traditional FM/AM radio tuner provides access to a wide range of radio stations, catering to diverse listening preferences.

Another notable technological highlight of the Aiwa CX-NA22 is its Bluetooth capability. This feature allows for wireless streaming of music from smartphones or tablets, providing the convenience of playing music without the restriction of wires. The integration of Bluetooth technology makes it easy to enjoy playlists and online streaming services directly through the stereo system.

The CX-NA22 includes a user-friendly interface with an LCD display, which shows track information and radio station details. The system features dedicated buttons for easy navigation, ensuring that users can quickly switch between different modes and adjust settings without hassle.

With its compact design, the Aiwa CX-NA22 is perfect for those with limited space but who still crave high-quality sound. Its stylish aesthetic will blend effortlessly into most home decor styles, enhancing both functionality and visual appeal. Overall, the Aiwa CX-NA22 stands out in the market of mini stereo systems, merging classic audio performance with modern technology for a well-rounded listening experience.
Top Page Image Contents