INSTALLATION INSTRUCTIONS
Step 1: Prepare installation
Do not lift the appliance by the door handle.
Remove the fixing screws from the polythene bag on the top of the appliance, but leave the appliance in the base tray packaging until you are ready to install it.
Whilst every care is taken to eliminate burrs and raw edges from this appliance, please take care when handling - we recommend the use of protective gloves during installation.
Please note that the weight of this appliance is approximately 48kg (unpacked). Take care when lifting it into the housing unit - always use an appropriate method of lifting.
Note: When removing the appliance from the base tray packaging care should be taken to ensure the appliance is not damaged.
Siting the appliance
If this appliance is to be installed near to a corner where the adjacen t cabinets run at right angles forward of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent overheating of the cabinets.
When installed in a typical 600mm deep built in housing unit, the false back should be removed from the housing unit, to provide the necessary depth for installation.
When the false back is removed, it is normally the case that the support shelf for the appliance leaves a gap between the back edge of the support shelf and the rear wall of approximately 80mm.
If no gap occurs between the back edge of the shelf and the wall behind the unit, you must create a gap of at least 30mm by shortening the shelf and any other shelf below the appliance.
Cut 12mm from the top of any plinth that may be fitted (see diagram).
Important: Do not modify the outer panels of this appliance in any way.
25