Glen Dimplex Home Appliances Ltd BI 90 G manual Commissioning Pressure test point, Burner aeration

Page 32

Installation Instructions

Step 5: Commissioning

Pressure test point

Use the oven burner. From inside the oven remove the burner cowl. Remove the small screw at the LHS of the burner cradle. Slide the burner to the left to access the injector.

Connect suitable T-piece (incorrporating a 115 injector) to the injector. Connect manometer to the T- piece and turn oven conrol to full on to check pressure.

Replace in reverse order.

Burner aeration

All burners have fixed aeration and no adjustment is possible.

Pressure setting

G20 Natural Gas @ 20 mbar

Electrical systems check

In the event of an electrical fault the preliminary electrical system check (earth continuity, short circuit, polarity and resistance to earth) must be carried out.

Ignition

The automatic ignition continues to spark for a short time after the burner has lit until the flame is established.

Oven (Top and Main)

Push in and turn the main oven control knob anti clockwise to the ‘FULL ON’ position (gas mark 9). The ignition system will spark automatically. Push in the control knob to ignite the gas. The sparking will stop. If after 15 seconds, the burner has not lit, turn off the oven and leave the compartment door open. Wait at least one minute before a further attempt to ignite the burner.

Do not hold the control knob in for more than 15 seconds.

Turn the control knob clockwise to the required setting.

To turn off, return the control knob to the “off” position.

Grill

1.The door must be open for grilling.

2.Push in and turn the control knob clockwise to the grill symbol.

When you first turn on the oven or grill you may notice a smell and some smoke which comes from the protective coating of oil burning off from some of the parts.

Before leaving the installation

Show the customer how to ignite the oven and operate the grill, and give them this handbook. Thank you.

30

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Belling BI 90 G If you smell gas Important NoticeContents Introduction Your 1st Year GuaranteeEvent of a power cut Ventilation For your safetyCooling fan Glass door panels CondensationTo replace a light bulb To replace an oven light bulb Environmental ProtectionBe Safe Not Sorry Never use the appliance for heating a roomUsing the Grill Grill operationPreheating Aluminium foilUsing the grill Oven shelves Using the OvensOven furniture Baking tray and roasting tins Using the top oven Replacing light bulbsIgnition top oven Zones of heat top ovenTop oven baking guide CakesBaking guide hints Pre-heatingZones of heat main oven Main oven baking guide Roasting guide LambRoast turkey Traditional fruit cakesCooking frozen & chilled foods Slow cookingUsing the Oven Semi-Automatic cooking in the mainovenProgrammer / Clock To select an alarm tone Setting the minute minderProgrammer buttons To set the time of daySemi-automatic cooking Semi-automatic cooking Duration method End Time methodCleaning Always let the appliance cool before cleaningChrome plated parts Enamel surfacesGlass parts Painted, plastic and metal finish parts if fittedStainless steel surfaces stainless steel finish models only Installation Instructions UK the regulations and standards are as followsInstallation Instructions Siting the applianceDimensions Typical example of a double pole fuse spur outlet Connect to the electricity supply Use a 13 amp fuse Connect to gas supply Make sure all connections are gas soundSecure appliance into housing unit Tosecure appliancetohousingunitPressure setting Before leaving the installationCommissioning Pressure test point Burner aerationTechnical Data Page Page Belling Customer Care 0844 815
Top Page Image Contents