Installation Specifications
Power Supply Requirements
WARNING
Electric shock Hazard – This appliance is equipped with a 40” (1016mm) power cord with a three prong grounded plug. Plug it only into a grounded three prong electrical outlet.
•Do not remove the ground prong.
•Do not use a
•Do not use an extension cord.
•Do not use a power cord that is frayed or damaged.
Failure to comply with the above can result in fire, electric shock, or death.
The electrical outlet for this appliance must only be installed by a licensed electrician.
Power cord with
Grounding type 
electrical outlet
The correct voltage, frequency and amperage must be supplied to the electrical outlet from a grounded, single phase circuit that is protected by a properly sized circuit breaker or
Circuit Requirements:
◊120 Vac, 60 Hz, 15 Amp. dedicated circuit.
Total Connected Load:
◊Model EWO36: 0.8kW (6.5 Amp.)
◊All other models: 0.5kW (4 Amp.)
NOTES:
1.The above specifications are for reference only. Refer to the product date label for exact specifications. If the requirements above do not agree with those listed on the product data label, use the information found on the label. See inside the front cover for location.
2.If the electrical service provided does not meet the product specifications, or does not conform to the NEC or local standards, do not proceed with the installation. Call a licensed electrician to install the required electrical service before proceeding.
3.Be certain to locate the electrical outlet in an accessible location, so that the warming oven may be easily unplugged if service becomes necessary.
4.It is the owner’s responsibility to ensure that the electrical outlet for this appliance has been installed by a qualified electrician. The electrical installation must comply with the latest revision of the National Electric Code ANSI/NFPA 70 and local codes and ordinances.
Installing the Support Platform in the Cabinet
Provide a platform (100lb. load capacity) within the cabinet upon which the warming oven will be supported. The platform must be installed level and straight. The top edge of the platform must be flush with the cutout at the front of the cabinet. There are no provisions to level the warming oven after it has been installed. 3/4” (19mm) thick plywood is recommended.
NOTE:
If the oven is not installed in a level fashion, the drawer may slide open on its own or may not seal tightly, allowing heat to escape and resulting in poor performance.
Chassis face
Support platform
6